Reed straw cutting and drying machine is a kind of agricultural machinery and equipment specially used for harvesting and drying reed straw. Its main function is to cut the mature reeds and dry them for subsequent processing and utilization. The use of reed straw cutting and drying machine can greatly improve the harvesting efficiency and reduce the labor intensity of farmers. The following is about the use of the reed straw cutting and drying machine::
Preparation: Before using the reed straw cutting and drying machine, the machine should first be inspected to ensure that the individual parts are intact and the lubricating oil is sufficient. At the same time, it is important to be aware of the local weather conditions and avoid working in bad weather.
2.Preparation before harvesting: Before harvesting the reeds, the growth of the reeds should be observed, and the reeds with moderate maturity should be selected for harvesting. In addition, weeds and obstacles in the harvesting area should be cleared so as not to affect the harvesting effect.
3.Start the machine: Place the reed straw dryer in a suitable position and connect the power supply and fuel lines. Then, turn on the engine switch to idle the machine for a while to check if the machine is running properly.
4.Adjust the height of the cutter: According to the height of the reed, adjust the height of the cutter so that it is at an appropriate distance from the reed. Generally speaking, the height of the cutter should be slightly higher than the height of the reed to guarantee the cutting effect.
5.Start harvesting: After confirming that the machine is working properly, you can start harvesting the reeds. The operator should stand on one side of the machine and control the throttle with one hand and the direction with the other. During the harvesting process, it is necessary to maintain the stable operation of the machine to avoid affecting the harvesting effect due to too fast or too slow speed.
6.Collect the reeds: The harvested reeds are transported to the rear of the machine via a conveyor belt. The operator needs to collect these reeds in time and stack them in a suitable place.
7.Drying of reeds: The collected reeds are dried. When drying, pay attention to maintaining a certain distance to facilitate air circulation. At the same time, it is necessary to avoid direct sunlight to avoid the deterioration of the reeds by heat.
8.End the operation: After the harvesting and drying work is completed, the power supply and fuel line of the machine should be turned off in time to clean up the dust and dirt on the machine. After that, store the machine in a dry, cool place for the next use.