Pump room casing plugging
Plugging leaks in the pump room is a common maintenance job, if you encounter similar problems, you may wish to follow along to understand the specific situation. This article will reveal the whole process of casing blockage in the pump room to help you save maintenance costs!
1: The reason for the plugging of the casing in the pump room.
There are many reasons for the plugging of the casing in the pump room, mainly due to the problem of the production process. Generally speaking, there are two causes of pipe blockage: one is the blockage caused by physical factors, such as scale, rust, etc.;The other is blockage caused by chemical factors, such as chemical corrosion, acid-base poisoning, etc. Typically, the production of liquids and gases from chemical materials produces large amounts of fouling sediments that can easily clog the fluid paths, causing them to flow poorly and affecting the proper operation of equipment. In addition, when water enters the tank or pipeline, it may also form a contaminated substance due to moisture, which can lead to clogging if it is not discharged in time.
2: Introduction to the process of casing plugging in the pump room.
Plugging leaks is a common cause of leaking pipes. Blockages are generally divided into two main categories, one is caused by deposits of solid particles or liquid substances;On the other hand, large bubbles form embolism due to the accumulation of gases and vapors. If you notice a leak in your pipeline, it may be due to a foreign object blocking the pipe, or it may be due to the valve not being closed properly or being damaged by an external force. It is not difficult to fix this situation, and it is only necessary to remove the foreign object to solve the problem. Normally, there will be a layer of oil, scale and other pollutants attached to the inner wall of the pipe, which are easy to corrode off, so just wipe the inner wall with a clean soft cloth dipped in some water.
3: How to fix a leak in a pipe.
When a pipeline leaks, the leak should be looked for and repaired first. If the leak is located outside the pipe wall, it can be repaired by separating the plug from the defect;For leaks located on the inner wall of the tube, it is often necessary to open the tube or take other measures to release the contaminant. During the repair process, there may be difficulties such as not being able to locate the complete leaking area or finding the right materials. At this point, it is advisable to contact the manufacturer for assistance. Once you have the right information, you can start the repair work. In such cases, many people choose to use pipe welding techniques to patch leaks. This method is not only simple but also inexpensive. However, pipe welding also has its limitations: it can only handle large diameter pipes and not small diameter pipes. In addition, pipelines are complex to implement because they are susceptible to environmental factors.
I hope that through the above content, we can help you and avoid unnecessary troubles and losses.