Punching holes in tiles requires some tips and precautions, here are some suggestions:
Choose the right tool: Choose the right drill bit according to your needs, such as glass drill bits, masonry drill bits, etc. At the same time, prepare tools such as hand hammers and angle grinders.
Determine the location of the punch: Select the location that needs to be punched in the tile, and make sure that there are no obstructions such as wires, water pipes, etc. in the tile.
Mark the punch location: Mark the location of the hole with a marker on the tile, you can also use a locator to locate it.
Pre-treatment of the punch position: Use an angle grinder to smooth the surface of the tile around the punching site to avoid damage to the drill bit when punching.
Start punching: Install the drill bit on the drill and make sure it is secure. Then, place the drill perpendicular to the tile surface and press the drill firmly to start punching holes. If you use an angle grinder for punching, you need to keep the angle grinder parallel to the tile surface and gently press down on the angle grinder to start punching.
Handle dustIn the process of punching, there will be a lot of dust, which needs to be cleaned at any time to avoid affecting the line of sight and operation.
Check that the hole is open: After the hole is punched, check whether the hole has been opened. If not, an angle grinder or hammer can be used to gently tap the drill bit to help open the hole.
Clean the holes: After the hole is opened, use a brush or hair dryer to clean the dust inside the hole to make sure the inside of the hole is clean.
Fixed items: If you need to fix items on the tiles, you can use materials such as cement, glue and other materials to fix the items on the tiles.
It should be noted that during the punching process, it is necessary to avoid using too much force or too much force to avoid damaging the tile or drill bit. At the same time, it is best to double-check whether the punching position and drill bit type are correct before punching to avoid wasting time and energy.
Autumn and Winter Check-in Challenge