Automobile generator wiring method.
1. The generator + battery positive pole is connected to the thin wire of the starter (the line of electromagnetic switch suction + two thick wires of the motor winding of the starter), after the engine starts, the generator's + battery positive pole is disconnected, and the generator will generate electricity normally after the circuit is broken.
2. The positive pole of the generator + battery is connected to the charging indicator of the dashboard, the negative pole is connected to the ignition switch, the ignition switch is connected to the negative pole of the iron, the ignition switch + the negative pole of the battery is connected to the thick wire of the starter, and the thick wire of the starter is separate and will not be connected with other wires.
3. Generator + battery positive pole connection + pole generator regulator, negative pole tie iron, + pole generator regulator + pole generator magnetic field f, regulator f pole connected generator n pole (after the ignition switch starts, f will follow the generator magnetic field f rotation, starter and generator magnetic pole are suction regulators, etc.) when starting, ignition switch + battery positive pole is connected to the starter thin wire (the line of electromagnetic switch suction + is the two thick wires of the starter motor winding), disconnect the starter thin wire after starting, The ignition switch is only the magnetic field f that controls the generator, and the regulator is mentioned above.
Fourth, the generator + battery positive pole is connected to the charging indicator, the negative electrode is connected to the iron, and the generator's + battery positive electrode is broken after the power generation will work normally (the charging indicator light will be turned off after the circuit is broken) to generate electricity when it is used and not to generate electricity when it is not in use.
5. After the engine starts, the positive pole of the generator + battery is broken (the charging indicator light is always on), and the three wires on the regulator are the wires that control the magnetic field of the generator, which are N, F1, and F2 (that is, the three thick wires), the positive pole of the generator - the positive pole of the battery is connected to the regulator-pole, the F of the generator is connected to the F1 of the regulator, the N is connected to the N of the regulator, and F2 is connected to the F2 of the regulator.
6. After the engine starts, disconnect the thin wire of the starter (the line of the solenoid switch suction + the two thick wires of the motor winding of the starter), and the engine will generate electricity normally.
7. There are four pins on the generator, which are B+ (that is, +), D+D-F and shell grounding.