Denitrification deep bed filter air-water distribution device - S-type filter brick is a third-generation filter brick product made of high-density polyethylene material, which has the performance of safety, environmental protection, filtration and long life. It can replace the traditional water cap plate and ceramic filter brick, and the installation is simple and flexible. Its design size is a single length 12 meters, area 033 square meters.
The installation method of S-type filter bricks can be operated according to the requirements of specific products. Here are the steps for a general installation:
1.Preparation: Check that the installation position is flat and cleaned.
2.Arrange filter bricks: according to the area and number of needs, arrange the S-shaped plastic filter bricks on the top of the sink or pipe according to the requirements.
3.Determine the spacing: According to the product requirements, determine the spacing between the filter bricks.
4.Fixed filter bricks: Use fixtures, connectors and other tools to fix the filter bricks in the installation position. The specific method may vary from product to product, and suitable tools and methods can be obtained according to the product description or consulting **.
5.Connect the tubing: Use the pipe connector to connect the filter brick to the pipe below to ensure that the water flow can flow through the filter brick.
6.Complete the installation: Check that the filter brick is installed securely and test the effect of the filter brick for water flow.
Note: The specific installation steps of S-type filter bricks may vary depending on the product, please follow the product instructions or consult the ** supplier for accurate installation information.