Have you all been in such a situation?
The water from the shower is getting smaller and smaller, some of the water outlets can produce water, and some of the water outlets can't spray water at all......”
I'll try it myself"Needle or toothpick".Poke poke, just poke it.
But I'll tell you:This approach will not solve the problem completely, but will only make it worse.
Because pinprick can destroy the water outlet hole of the shower, causing uneven water flow and leakage.
It may also cause the dirt and scale that clog the outlet hole to accumulate and become stronger, making it easier for the outlet hole to be blocked and not water.
So, how to solve the problem?
First of all, we need to understand the cause of the problem.
1.It could be that the water pressure is insufficient.
We can open it for a longer period of time, at different times, and if the shower can produce water normally, there is no need to toss the shower, because the shower itself is fine.
2.It could be water quality.
If the water quality is too poor, a lot of scale will form inside after heating, and it will enter the shower along the water flow, and then it will continue to precipitate, slowly blocking the water outlet hole of the shower, resulting in the water outlet hole being blocked.
3.It may be a problem with the quality of the shower.
The workmanship of the shower is rough, and the design of the outlet hole is unreasonable, so it is likely that there will be water leakage, water volume reduction or water outlet deviation in the process of daily use.
Secondly, prescribe the right medicine to solve the troubles.
How to do it?
Today, I would like to share my experience with you.
【1】 Soak in white vinegar
Go to the supermarket and spend 1 yuan to buy a bottle of edible vinegar, then find a small container to put the shower, then pour a little laundry detergent and a large amount of edible vinegar into it, soak it for 3-5 hours, find a discarded toothbrush to brush the water outlet hole of the shower, remove scale and impurities, and the water outlet hole can be smoothed immediately.
The general temperature has a slight effect on the rate at which the scale dissolves.
If you want to hurry,You can heat the vinegar slightly and control the heating temperature below 70 degrees CelsiusVinegar does not volatilize, but also acts as a "catalytic" effect, breaking down the water stains and limescale hidden in various places inside the shower more quickly.
Tips:
Acidic substances such as vinegar and lemon juice can soften limescale and allow it to break out of the shower hole.
Because limescale is alkaline,"Acid-base neutralization".After that, the scale impurities will decompose.
Therefore, whatever acidity is available at home, it is good to use whatever acidic substance you have.
Of course, if there is more than just a problem with the water hole of the showerThe shower is rusty, deformed, or leakingWe need to replace the shower in time, otherwise the problem will only get worse, which will affect both the use and our health. In this regard, I suggest you try the second trick!
[2] Replace the shower with a better quality
Showers look similar, but the quality is very different.
When we buy a shower, it is best to choose a big brand, and the quality and after-sales are better.
I suggest you try the [Bath Mans 5-speed shower].
As a rising "new star" in domestic products,Produced by Yumans, the quality is high, and the after-sales service is also good.
Online shopping, you can return or exchange at any time, and return it for no reason within 7 days.
The cost performance is extremely high, only a dozen yuan,
You must know that a shower of the same quality will cost more than 100 yuan in a physical store.
It is a very high-end showerThe principle of air pressurization can be used to ensure that when the water is tight, the water pressure is stable and the water is fast and fierce. It is very suitable for high-rise residents and remote usersFor a region like ours where water is not stressed, it can also be the "icing on the cake".
Because it has 5 ways to get out of the water.
For example, rain, massage, mixing, etc., we can use different water modes for different moods and needs to achieve the purpose of massage and cleaning, and improve the happiness index of the shower experience.
And the bath mans showerAlthough the amount of water produced is large, it does not require much water at all.
Because it makes the water delicate, it gives people the illusion of a large amount of water, but it is actually similar to the water used by ordinary showers, but it makes people feel more comfortable.
Plus its configuration"One-click water stop".The water can be stopped immediately at any time, and the water temperature is not changed before and after the water is stopped, so the bath mans shower has now had many "repeat customers", and the praise continues.
So if your shower is not good, the shower is leaking and the water output is low, you must try it!
The shower has only 0 per spout3mm，Even in pulse mode, it just looks ferocious, hitting the body, more like a massage, very comfortable, suitable for all ages.
It's still made of siliconeEven if the local water quality is poor and contains a lot of impurities, it can be used for a longer time.
Because it contains filter cotton inside, it can filter impurities in the water as well as sterilize;It is also very clean, usually the water outlet hole is blocked, brush it with a waste toothbrush, and the water output of the water outlet hole can immediately become more and fierce!
Write at the end,
Have you all learned the above methods?If there are other home problems or solutions, please leave a message to share. Your needs are the driving force for the author's continuous cultivation
Warm Winter Good Thing Award