With the increase in productivity, the requirements for purification equipment in factories are getting higher and higher. Many users will have high requirements when choosing a dryer.
1.The multi-pipe modular design of the adsorption chamber and the patented design of the cylinder block make the fuselage structure compact and reasonable, and the volume is small
2.The modular dryer uses the most advanced molecular sieve in the world as the adsorption material
3.The inlet and outlet buffer chambers are added, so that the air flow through the inlet and outlet buffer chambers through the adsorption chamber to form convection, thereby reducing the pressure drop, reducing pressure loss, low regeneration air consumption, slight heat less than 3%, no heat less than 6%;
4.The unique silencing emission design realizes the instantaneous discharge of compressed air in a low-noise state, so that the moisture adsorbed on the surface of the molecular sieve can be fully discharged, reducing the loss of regenerated gas. The regenerative gas flow can be adjusted so that the regeneration gas is always in an ideal state;
5.Wearing parts are easy to disassemble and assemble, and easy to maintain. The cylinder is used as the actuator, and the maintenance cost is low. It can effectively treat moisture in compressed air, **range -20 -70 optional.
Extended reading: Characteristics of adsorption dryer desiccant.
Everyone knows that the adsorption dryer is good or not, and choosing the right desiccant is the key. Usually, different models of adsorption dryers will choose different desiccants. So how to choose the right desiccant, then we must first understand the characteristics of the desiccant. The adsorption dryer generally uses silica gel, activated alumina, and molecular sieve as desiccant.
In the adsorption process, the higher the compressed air pressure, the better, the lower the temperature, and the lower the air velocity, the better. At present, the most widely used adsorbents in adsorption dryers on the market are activated alumina and molecular sievesAlumina has a higher strength but poor adsorption capacity, and molecular sieves have three times the adsorption capacity of alumina, but the strength is very low. The modular adsorption dryer and the mold core adsorption dryer fully use molecular sieve as the adsorbent, which is very guaranteed in the drying effect. Silica gel is more susceptible to moisture deliquescent. The adsorption performance of activated alumina is very strong and stable, it does not deliquescent when encountering water, and has high crushing strength and abrasion resistance, and has a wide range of applications. Due to its good drying performance below the relative humidity of 20, molecular sieves are often only used as a desiccant for deep drying.
If you want the adsorption dryer to be easy to use, you must choose a good desiccant.