There are many places where high-flow submersible pumps are used, such as: rafting, playgrounds, standardized irrigation, storage and drainage, etc.;The installation methods are also varied, which can be reasonably arranged according to customer requirements and specific working conditions on site, so that the operation effect of the pump is better and the service life of the equipment is prolonged.
Autumn and Winter ** Counterattack GuideUsage: (High Flow Submersible Well Pump).
** type submersible electric pump is an important equipment for deep well water lifting. The whole unit of this product is connected by a water pipe. Dive into a deep well to run below the moving water level. Groundwater is extracted to the surface through aqueducts. For urban and rural workers. Water use for mining enterprises. and farmland irrigation. Such as the use of high-temperature resistant materials. Can be used up to 120 degrees. Extraction of groundwater hot water. Corrosion-resistant materials are used. Such as stainless steel. It can be used for seawater transportation. and the delivery of corrosive liquids.
Features:
The electric pump is well designed. Rationally structured. Small size. Lightweight. It has low noise. Long service life. Easy installation and maintenance.
Conditions of use:
Voltage 380VThe deviation does not exceed 5%.Frequency 50HzThe deviation does not exceed 1%.Three-phase AC power.
The inner cavity of the motor must be filled with distilled water (or clean clean water).
The D-level impeller of the water pump should be at least 3m below the moving water levelThe intrusion of the entire electric pump unit is not more than 70m below the static water levelThe bottom of the motor is not less than 5m from the bottom of the well
The water temperature is not higher than 20 degrees.
The solids content (by mass) in the water is not greater than 001%
The pH of water is 65-8.5
The content of hydrogen l in water is not greater than 15mg/l
The content of chloride ions in water is not more than 400 mg l.
Large flow submersible well pump, high head, easy to use.
1. The pump shaft is made of stainless steel made of 2Cr13, which has good toughness and strong hardness.
2. Shell casting: high precision, strong hardness, beautiful appearance.
3. All kinds of water conservancy parts: high efficiency and high precision.
4. Motor: 100% pure copper (good conductivity).
5 protection class IP68, insulation class F and so on.