There are a total of 4 modes for selection, and the following is a detailed introduction for you to see which mode you are most suitable for.
a.Half-wave longitudinal vibration system for 50mm wires up to 70mm wires. Due to the pressure warping problem, it cannot exceed 70mm.
b.The full-wave longitudinal vibration system can cover all line ranges, but there are inconvenient problems in operation. For special-shaped (sonotrode needs to avoid space) terminals, the adaptability is not strong.
c.The torsional vibration system can cover all line ranges, and the inconvenient operation problem is better than the full-wave longitudinal vibration system, and the space avoidance problem is worse than the bending vibration system.
d.The bending vibration system covers all wire ranges and is easy to operate Optimal terminal adaptability (avoidance characteristics). The disadvantage is that the current equipment and accessories are higher.
Welding principle of automobile terminal welding machine: ultrasonic metal welding is to use the energy generated by high-frequency vibration to infiltrate the same or different metals with each other through cold grinding and horizontal movement under appropriate pressure to achieve the purpose of welding. There is no need for flux and external heating, no deformation due to heating, no residual stress, and low requirements for pre-welding treatment on the surface of the weldment. Not only the same kind of metal, but also different metals can also be welded with each other. Thin sheets or filaments can be welded to thick plates.