To set up dual play, you need to configure it in the router's management page.
First, go to the settings interface of the router, select the WAN port configuration, set the WAN port of the two networks to the same gateway, and enable the IP address overlay function.
Next, set the LAN ports of the two networks to the same network segment in the LAN port configuration and enable the dual-play function.
Finally, save the configuration and restart the router to complete the setup of the dual network. Note that you need to double-check the configuration information during the setup process to ensure that the settings are correct.
The dual network port recorder setup methods are:
Multiple access setting mode (connecting multiple network segments). Set the working mode of the NVR to Multiple Access Setting, and select NIC lan1 and lan2 to set the corresponding network parameters.
Port aggregation mode (dual-line bandwidth overlay). The two network cards use the same IP address to bring together the two network ports of the recorder to form a logical physical port, which can increase the bandwidth after aggregation
The two network ports dynamically back up each other to improve connection reliability.
First, connect the two network ports of the dual network port recorder, one for connecting the monitoring equipment, and the other for connecting the network.
Then enter the settings page of the recorder and set the network, including IP address, gateway, subnet mask, etc., to ensure that the network connection is normal.
Then the recording settings of the video recorder are carried out, including the recording mode, recording resolution, recording time, etc., and the settings are set according to the actual needs.
Finally, set the alarm settings of the video recorder, such as motion detection, occlusion alarm, etc., to ensure that the video recorder can find abnormal situations in time and record the video. After the above settings are completed, the dual network port recorder can work normally.
The method of integrating multiple bands is as follows:
Prepare the device: You'll need at least two routers (which can be increased or decreased depending on your needs) and a new switch. In addition, you'll need to assign a suitable IP address to each router, such as 192168.1.1 and 192168.1.2。
Connect the router: First, connect the cat (modem) to the router. Then, connect the LAN ports between the routers through a network cable. For example, connect the LAN port of Router 1 to the LAN port of Router 2, and then connect the LAN port of Router 2 to the LAN port of Router 3.
Configure routers: Log in to the management interface of each router and configure dial-up Internet settings. In the Router Properties, enter the broadband account number and password in the appropriate locations. Make sure that the dialing settings are the same for each router.
Set IP address: Set a unique IP address for each router, such as: 168.1.2 and 192168.1.3。This step is to avoid IP address conflicts between routers.
Turn off DHCP: Turn off DHCP in your router's settings to avoid IP address conflicts between devices.
Connect to the switch: Connect the network cables of all computers, printers, and other devices to the switch. Make sure that the IP address of the switch is not in the same subnet as the router, for example, set to 192168.2.1。
Configure your computer's IP address: Log in to your computer's local connection settings and set the IP address to 192168.1.x (x is a number between 1-254) and the subnet mask is set to 255255.255.0, the default gateway is set to the IP address of the router.
Test: After completing the above steps, make sure that all devices are able to connect to the network normally. You can use your computer to ping your router and switch to check if the network is unblocked.
Through the above steps, multiple broadband bands have been successfully integrated and superimposed. Now, you can enjoy faster network speeds and a better LAN experience.
At this point, the above is the question of how to set the gateway password for the stack gateway settings, and I hope these 3 answers will be useful to you.