Many customers have reported that their oil mold temperature machine can not be used well when it is used again after a period of time. It is not easy to use for a long time, and the main reason is that the storage method of the oil mold temperature machine is incorrect, or it is not done according to the relevant storage requirements, so that when the oil mold temperature machine is not used for a long time, no one maintains it and the storage is not right, it will easily cause the equipment to be not easy to use.
If there is no need to use it for a long time or for the time being, it is necessary to carefully store the oil mold temperature machine. Specifically, it is necessary to do this.
When the mold temperature machine is not in use, please be sure to disconnect the cooling water connection pipe, and clean up the remaining cooling water and heat transfer oil in the pipe, and pack it and store it in a dry place. Before storage, clean all parts of the oil-type mold temperature machine, repair the damaged places, and add lubricating oil to those that need to be lubricated. Some special places, such as serious paint peeling or peeling parts, still need to do relevant anti-rust treatment, and also need to be repainted. In this way, you can choose to store it in a dry room, and choose it on a flat ground to ensure that it will not affect the access and maintenance of other equipment. Then cover the oil-type mold temperature machine with a cloth to avoid too much dust.
As a general rule, the mold temperature machine should not be stopped for a long time. If it must be stopped for a long time, the cooling water line must be thoroughly purged with air. Due to the large number of tube bundles in the heat exchanger, it is easy to make the purged air short-circuit, so that the water in a part of the tube bundle cannot be blown out. Especially after the advent of winter, the uncleaned pipe bundle freezes and cracks, and the cold exchange equipment is scrapped. Therefore, when purging, the amount of air should be sufficient to ensure that there is a sufficient flow rate, and repeat it many times until the water is clean. Before winter, it is necessary to strengthen the insulation with felt or rock wool and wrap it with anti-freezing materials.