A detailed guide to the wiring method of the elevator access control systemFirst, prepare the necessary tools and materials, including screwdrivers, wires, power plugs, etc. Then, carry out a power-off operation to ensure safety. Next, do the power wiring, locate the elevator's electrical outlet, plug it in, and ground it. Then, find the interface of the elevator button on the elevator access control contact panel and connect it with the appropriate cable. Next, connect the card reader to the elevator control interface of the elevator access control panel, make sure the interface matches and secure the cables. Next, the elevator control fire linkage wiring is carried out, and the automatic disconnection of the boat-type switch is connected to the COP interface of the elevator control panel. Then, the elevator access control is debugged and operated, and all functions are checked to see if they are working properly. Finally, card issuance and acceptance handover are carried out to ensure that all hardware is working properly on site, and basic training is done for property management personnel. This guide is very detailed and covers all aspects of the wiring method of the elevator access control system.
A detailed guide to the wiring method of the elevator access control system.
When installing an elevator access control system, it is very important to understand its wiring method. Here's a detailed guide to help you get your elevator access control system wired smoothly.
1. Preparations.
Before you start wiring, you need to prepare the following tools and materials:
1.Screwdriver.
2.Wire.
3.Power plug.
4.Insulating tape.
5.Label paper.
Second, power-off operation.
Before performing any actions related to the elevator access control system, make sure that the elevator is powered off. This is to ensure safety during operation.
3. Power wiring.
Locate the elevator power outlet, plug the power plug into the outlet, and make sure the plug is grounded. Make sure the power cord is well secured to avoid any possible risk of electrical fire.
Fourth, the elevator button interface connection.
On the elevator access control elevator control contact panel, find the interface corresponding to the elevator button. Connect the elevator keys with the control panel using the appropriate cables. Make sure the connection is secure and use insulating tape to secure the cable.
5. Connect the card reader.
Connect the card reader to the elevator control interface of the elevator access control panel. Make sure the interfaces match and use the appropriate cable to connect. Make sure the cable is well secured and secured with insulating tape.
Sixth, ladder control fire linkage wiring.
If your elevator access control system needs to be linked to a fire protection system, follow the manufacturer's instructions for wiring. Typically, you need to connect the automatic disconnect boat switch to the COP interface of the elevator control panel. Make sure the wiring is correct and label each connection with label stock.
7. Elevator access control commissioning and operation.
After all the wiring work is completed, the commissioning and operation of the elevator access control system is carried out. Check that all functions are working properly, including elevator buttons, card readers, etc. If you find any problems, please adjust and fix them in time.
8. Card issuance and acceptance and handover.
Once you've confirmed that the system is working properly, you can start issuing cards to the right people. At the same time, provide basic training to property managers on how to operate and maintain the elevator access control system. Finally, complete the acceptance and handover procedures to ensure that all hardware sites are working properly.
This guide covers all aspects of the wiring method of the elevator access control system, and I hope it will be helpful to you. Please note that safety always comes first when performing any elevator-related operations. If you are unsure about a certain step or have any doubts, please consult a professional.
Elevator access control system wiring guide. First, prepare the tools and materials. Then, power off the operation to ensure safety. Next, wire the power supply and connect the elevator buttons. Connect the card reader to the elevator access control panel. Carry out ladder control fire linkage wiring. Debug the run and check if the function is normal. Finally, card issuance and acceptance handover to ensure that all hardware works properly on site. This guide is detailed and covers all aspects of the wiring method of the elevator access control system.