The process of installing and uninstalling the reversing lenses can be referred to the following steps:
1. Install the reversing lenses.
Open the rear door of your vehicle and find the adjustment button in the mirror, usually on the driver's side door panel or on the left side of the dashboard.
Turn the adjustment knob to the position of the rearview mirror where the reversing lens needs to be installed.
Open the card slot of the reversing lens and align the raised part of the card slot with the notch in the base of the mirror.
Put the reversing lens into the card slot and press it gently until you hear a click, indicating that the lens has been successfully installed.
Repeat the above steps to install the reversing lens on the other side.
2. Unload the reversing lenses.
Open the rear door of your vehicle and locate the reversing lens that needs to be unloaded.
Press the fixing button on both sides of the reversing lens, usually at or below the edge of the lens.
Grasp the reversing lens with your hand and gently pull it out to the outside until you hear a click, indicating that the lens has been successfully unloaded.
Repeat the above steps to unload the reversing lens on the other side.
It should be noted that the installation and unloading methods of reversing lenses may be slightly different for different models, it is recommended to refer to the vehicle's instruction manual or consult a professional maintenance personnel for more detailed guidance. At the same time, to ensure safety and avoid damage to the vehicle, it is recommended to use appropriate tools and follow the correct operating procedures when installing and unloading the reversing lenses.
Autumn and Winter Check-in Challenge