Highlander burn oil can be repaired with the Spec PNF technology. This technology is specially developed for the problem of burning engine oil, by going deep into the molecular level of engine oil, cleaning the whole oil circuit, and releasing the piston ring through multiple driving, so as to solve the problem of burning engine oil caused by piston ring stagnation. The process of reconditioning the burned engine oil with PNF stock solution is not complicated. The specific steps are as follows:1Inspection: Inspect fittings such as oil seals, wastegates, and turbines to rule out accessory issues. 2.Fix: - Fuel additives: one tank of oil plus three bottles, six tanks of oil in a row. - Oil additives: use one service cycle and use two service cycles continuously. It should be noted that different vehicles and engines may have different usage methods and precautions, and there are professionals in the Consulting Division before use.
Yes, the PNF technology is safe and reliable. The repair agent using PNF technology can be added to the fuel tank to solve the problem of burning oil, this repair method is achieved through the continuous driving of the vehicle, so that the piston runs back and forth between the upper and lower dead center, and the more times it travels, the higher the frequency in a short time, so it is similar to the principle of the bubble cylinder and the disc shaft, but the repair process is completed by using the engine's own heat and automatic running disc shaft, and there is no need to remove the oil pan, nor do you need to worry about the residual value of the vehicle, which is relatively safer and more reliable.
There are several reasons why Highlander burns engine oil:
1.Piston ring stagnation: The piston ring is used to ensure the tightness between the piston and the cylinder wall to prevent blow-by and oil leakage. If the piston ring is stuck, it will cause the oil to burn. Most common.
2.Valve oil seal damage: Valve oil seal is used to ensure the tightness between the valve and the valve guide to prevent blow-by and oil leakage, which is rare. If the valve oil seal is damaged, it will cause the engine oil to burn.
3.Turbocharger failure: A turbocharger is a component used to increase engine intake pressure, which in turn increases engine power and torque. If the turbocharger fails, it will cause the oil to burn. Rare.
4.Oil quality problems: If you use oil that does not meet the standards, or if the oil is aging or deteriorating, it will lead to the phenomenon of burning oil. It is important to note that different vehicles and engines may have different causes of burning oil.