Pure water equipment During the operation of pure water equipment, overheating of the water pump is a common problem. Overheating of the water pump will not only affect the normal operation of the equipment, but may also shorten the service life of the equipment.
1. Power supply reason: too high or too low electricity. Solution: The pure water equipment should be installed with a phase loss protection device. 2. The reason of the pump itself: the power is not matched, the horse-drawn carriage and the motor are overloaded for a long time, so that the motor temperature is too high. Solution: The number of starts should be limited and thermal protection should be selected and used correctly according to the calibrated quota on the motor. 3. The reason for the motor itself: the connection is wrong, and the triangle is wrongly connected into a Y shape, which makes the temperature of the motor rise rapidly. Solution: If the air system of the pure water equipment fails, check whether the fan is damaged, whether the rotation direction is correct, whether the ventilation duct is blocked, and whether the ventilation duct is blocked. Bearing wear and rotor eccentricity sweep stator and rotor core rub against each other, making a metal impact sound, and the core temperature rises rapidly. In severe cases, the motor emits smoke and even the coil burns out. 4. Reasons for the working environment: the motor winding is wet or has dust, oil stains, etc. Solution: The ambient temperature is too high, when the ambient temperature exceeds 35, the inlet temperature is high, which will make the temperature of the motor too high, so try to improve its working environment and build a shed to shade the sun.
Keep the environment around the water purification equipment clean and avoid debris and foreign matter inside the water pump. At the same time, it is also necessary to pay attention to prevent water pollution, so as not to cause adverse effects on the equipment. The operators of pure water equipment should be trained to be familiar with the operating procedures and maintenance knowledge of the equipment, so as to improve the operation efficiency and life of the equipment.