What details need to be paid attention to when pre embedding the bottom box during the construction

Mondo Home Updated on 2024-02-01

Home decoration circuit construction, the burial of the bottom box is often ignored by many owners, but in fact, it is very important, if the bottom box is embedded with deviation, it will directly affect the quality of decoration construction, in addition to the reputation of the construction party and the satisfaction of the owner to cause serious damage, the follow-up switch panel installation is not in place may also cause safety accidents.

So what do you need to pay attention to when pre-embedded bottom box? Share it with you below:

First, the depth of embedding.

The depth of the commonly used bottom box is generally 45mm, so the depth of the installation slotting should be between 45mm and 55mm;

Second, the choice of the bottom box.

If there is no special need, the general 86 type bottom box, considering the durability and safety, it is best to choose the seamless splicing bottom box of Dacroll ear buckle to avoid problems such as inconsistent spacing and screw falling off during installation.

3. Fixed correction.

When fixing the bottom box, the level should be corrected to ensure that it is horizontal and upright, if you use a seamless splicing bottom box, only three points of positioning are required, which is simple and convenient to operate compared to the traditional bottom box, and even if multiple back boxes are connected, it is not easy to misplace, and the subsequent switch panel installation can maintain the same level.

Fourth, the cup comb connection.

There should be a cup comb connection between the wire pipe and the bottom box, and it is best to install it before burying it to avoid scratching the wire insulation layer when the subsequent threading and pulling wire;

5. Install a protective cover.

The protective cover can prevent the risk of leakage and electric shock, which can not only ensure the safety of construction personnel, but also play a protective role for the wires in the box, reducing a lot of trouble caused by construction.

6. Sprinkling water and dusting.

After the chiseling is completed, clean the ground in time, especially the sand and dust of the line groove and the box groove, and wet the box groove with water before embedding, so as to facilitate the stability of the bottom box after burial.

If you want to decorate and look good, every detail must be standardized, and everyone should pay close attention to these details embedded in the bottom box, otherwise the subsequent installation of the more expensive switch panel will be blind. I hope today's sharing can help you, and you are welcome to exchange corrections in the comment area

Related Pages