The installation steps for a single turnout are as follows:
1.Prepare the work, clean up the debris on the site and ensure that the construction site is clean and tidy. Make a construction budget according to the actual site situation. Follow relevant safety regulations and process standards for job preparation. Clarify the personnel and material access management regulations and power setting methods and other key link control point responsible persons, and hang signs to give clear warnings. 24-hour emergency duty** announced to the public for easy contact with the outside world (timely communication in the event of an accident). In addition, the required equipment and tools need to be inspected to confirm their quantity and completeness, so as not to affect the normal operation. 3. Measure and position the pay-off, and determine the position of the opening according to the design drawingsAccording to the gauge column pile, adjust the straight steel track turnout and measure the distance of the back rut of the dialingThe above is part of the content for reference only, and the specific process needs to be adjusted according to the actual situation of the project!After the turnout is laid, it needs to be used only after the quality inspection and acceptance of the maintenance personnel, and it is also necessary to strengthen maintenance to ensure normal use in the process of putting it into use /---
As for how to change from the "one" line to the fork line, the following steps are required: first, after adjusting the sharp rail (i.e., the distance between the basic rail and the traction point), pay attention to the locking temperature and enter the preset elevation when it reaches the allowable locking rangeAt the same time, it is also necessary to use the method of pulling the slope or ultra-high to make the top iron of the two completely close, and then supplement the other requirements in the inspection and maintenance specifications, such as the limit and value of the joint wrong tooth, etc., to complete the operation! In short, for such a process, it is still necessary to systematically learn to better understand and masterThe above is some suggested information for your reference, I hope it will be helpful to you!