There may be several reasons why the Little Swan washing machine is not dehydrated:
Uneven or too much laundry: When the washing machine is working, if it detects that the laundry is unevenly distributed or too much, it will automatically shut down with a UB error. This usually happens when the washing machine is centrifuging at high speed, because the speed of the washing machine is fast, and if the laundry is not evenly distributed, it will cause the washing machine to shake or shake, resulting in UB errors. The solution is to redistribute or reduce the number of clothes to ensure that each item is evenly distributed in the washing machine.
Abnormal water level sensor: The water level sensor is an important part of the Little Swan washing machine, which can sense the water level in the laundry bucket and control the operation of the washing machine. If the water level sensor is abnormal, the washing machine will not be able to accurately sense the water level, resulting in the inability to spin properly. The solution is to check whether the water level sensor is abnormal, if there is an abnormality, it needs to be repaired or replaced.
Clogged drainage system: The washing machine needs to drain water before dehydration, if the drainage system is blocked, the water level switch cannot be reset, the washing machine cannot drain water, and naturally it cannot proceed to the next step of dehydration. The solution is to clean the drain filter and flush out the debris in the drain and drain valve.
Motor failure: If the motor does not rotate or rotates at low speed, it means that the motor is faulty and needs to be repaired or replaced. In addition, the thermal protection of the motor may also result in the inability to dehydrate, at which point the machine can be shut down and started again after a certain period of time.
Solenoid valve damage: The inner barrel of the washing machine is rotated by converting the gear at the bottom of the solenoid valve, if the solenoid valve is damaged, it cannot be dehydrated, in this case, the solenoid valve can be replaced.
Damaged top cover switch: If the cover is not properly covered or the top cover switch is damaged, it will not be able to dehydrate, and a new switch needs to be replaced.
In addition to the previously listed reasons, the reasons for the failure of the Little Swan washing machine to dehydrate are:
Loose motor plug: Since the connecting wires of the drum washing machine are all connected with connectors, during transportation, the motor plug may be loose or the plug piece may be ejected during installation due to vibration and other reasons. If the plug is loose, it should be replugged in and tied tightly with a strapping wire to prevent it from falling off again.
The brake is not released: It may be that the motor cannot be started due to excessive load. At this point, when a buzzing sound is heard, the drain tie bar can be adjusted.
Damaged computer boards: Problems with computer boards can cause non-drainage, often requiring repair or replacement of the computer board.
Retractor Problem: If the pawls and ratchet of the retractor clutch are not disengaged, it may be that the adjustment rod nut of the drain valve is loose or worn, resulting in insufficient opening distance. At this point, the distance of the adjustment lever should be readjusted so that the pawls of the clutch and the ratchet wheel are disengaged.
Drain valve blockage or drain solenoid valve failure: Check whether the adjusting rod nut on the drain valve is loose, causing the tractor to fail to open the drain valve core, resulting in poor drainage. At this time, the nut should be fixed and the drain valve spool should be opened.
Unstable feet of the washing machine: Whether the feet of the washing machine are stable or not is also a factor affecting dehydration, and the feet of the washing machine need to be adjusted.
It should be noted that the above are only possible causes, and specific problems need to be analyzed on a case-by-case basis. If the cause cannot be determined or the problem cannot be solved, it is recommended to contact a professional maintenance personnel for inspection and repair.