When encountering the problem of high water content of flash dryer products, the first thing that needs to be checked is whether the exhaust temperature is set low. If this is the case, the feed can be reduced appropriately and the exhaust gas temperature can be turned up to help the water evaporate better. On the contrary, if the moisture content of the product is too low, then the feed amount can be increased appropriately and the exhaust temperature can be appropriately reduced to achieve a balanced drying effect.
When there is a rapid drop in mixing temperature, no product emissions, or reduced emissions, it is necessary to check whether the feed volume is too large. If the feed volume is too much, it may cause the material to not evaporate completely during the drying time. At this time, the outlet temperature can be appropriately increased, and the inlet temperature and feeding speed can be adjusted to ensure the drying effect of the material.
In industries such as chemical and minerals, factories often choose different types of machines to handle powdery, lumpy, and granular materials. In order to ensure that the material meets the standard, the flash dryer has become the equipment of choice in the factory.
The material enters the machine through the feed channel and is fed into the drying area in batches by the feed pump. In this process, the right amount of air is introduced into the machine to provide the necessary heat energy for the drying process. As soon as the machine is started, the material begins the drying process.
With the continuous advancement of technology, the operational performance of the flash dryer has been significantly improved, making it easier to operate. Flash dryers have the characteristics of high efficiency, energy saving and environmental protection when processing materials, so they have been widely used in many fields. At the same time, in order to ensure the normal operation of the equipment and the best drying effect, regular maintenance and maintenance are required, and close attention is paid to the operating status and parameter changes of the equipment.