Compared with the electric ordinary tire scraper, the electric single-cylinder tire scraper has one more cylinder, which is more time-saving and labor-saving to operate, the electric ordinary model needs to be plugged in, first pull out the disassembly bracket bird head, before disassembling the tire, the tire must be lubricated with lubricating paste, the purpose is not to hurt the tire mouth, afraid that the friction is too large The tire can not be installed, put the tire up, two fixed pins into the steel ring hole, and press the steel ring with the steel ring pressing plate assembly to prevent the steel ring from moving when disassembling the tire, and the disassembly and assembly bird head is placed on the machine. Disassemble and assemble the bird's head close to the steel ring, and the side is flush with the steel ring.
Disassemble the upper tire opening, use the head of the tire lever to lift the upper tire opening, the tire lever should be flattened, so that the head of the tire lever and the steel ring leave the 5mm gap, lift the tire on the opposite side of the cylinder upward, make the tire on one side of the cylinder sink, and jack the lower tire mouth to the cylinder to prepare, first extend the head of the tire lever into the tire, press the remote control switch, and the tire will be jacked up, so that the tire is disassembled and assembled.
The electric tire scraper should lubricate the tire port before disassembling and installing the tire, put the tire half on the machine before loading the tire, and use the remote control (rotate around) to drive the disassembly bracket bird head to complete the tire lower tire port installation, and when installing the tire, it is necessary to slightly press the upper tire port to drive the bird head to complete the operation.
The oil cup on the electric single-cylinder tire scraper is used for the first time or continuously for 6 hours, 32 hydraulic oil must be added, and the cylinder is always lubricated, the electric single-cylinder tire scraper has one more cylinder than the electric ordinary tire scraper, on the basis of the need for electricity, it is also necessary to connect the air pump, and the operation method of the electric ordinary tire scraper is the same, but there is one more cylinder than the electric ordinary tire scraper, and the lower tire port of the tire is lifted by manpower, and the lower tire port can be pushed out of the upper edge of the steel ring directly with the cylinder, Insert the scraper head into the gap between the top of the lower tire opening, and install it in the same way as the regular model. For more product knowledge of tire scraper, please contact Baoding Zhuoheng Machinery Manufacturing