I. Introduction.
As an important place to hold criminal suspects, the security and confidentiality of prisons are of paramount importance. As the first line of defense for prison security, the security of the door is the top priority. As a new type of door product, the soft package security door has high safety performance and anti-vandal ability, so it is widely used in prisons. This article will introduce in detail how to make a prison soft pack security door.
2. Preparation of materials.
The following materials are required to make a prison upholstered security door:
1.Steel plate: The high-quality steel plate with a thickness of 3-5 mm is selected, which has good strength and durability.
2.Soft materials: such as bulletproof nylon cloth, high-density sponge, etc., which are used to fill the door body and enhance the cushioning performance of the door.
3.Locks: Locks with high security performance are required, including but not limited to combination locks, fingerprint locks, etc.
4.Electronic equipment: such as surveillance cameras, alarms, etc., for monitoring and alarming.
5.Other materials: such as screws, welding materials, sealants, etc.
Third, the production process.
1.Cutting and bending of steel plates.
According to the design drawings, the steel plate is cut and bent using a cutting machine and a press brake to form the prototype of the door frame and door panel. It is required that the cutting edge is neat and the bending angle is accurate.
2.Bulletproof nylon cloth with sponge filling.
Cover the door panel with a bulletproof nylon cloth and secure it with a special glue. It is then filled with high-density sponge to ensure that the door panel is flat and dense. The inside of the door frame should also be covered with bulletproof nylon cloth and filled with sponge to improve the door's impact resistance.
3.Electronic equipment and lock installation.
According to the design requirements, install electronic equipment and locks. For example, install a security camera above the door panel, install a combination lock on the door frame, etc. Ensure that all equipment is securely installed and accurately positioned.
4.Sealed treatment.
Use sealant to seal the gaps in the door to prevent external attackers from breaking the door security through the gaps. At the same time, the sealing treatment also improves the sound insulation of the door.
5.Quality inspection and commissioning.
After completing the above steps, the quality inspection and debugging of the soft package safety door are carried out. The test content includes the ballistic performance of the door, the anti-collision performance, and the opening and closing normality of the lock. If there is a problem, adjust and improve it in time.
6.Packaging & Shipping.
Finally, pack the pouch security door to ensure that it will not be damaged during transportation. The packaging materials should be wear-resistant and compression-resistant, such as wooden frames, foam pads, etc. Be careful during transportation to ensure the safety and integrity of the door.
4. Precautions.
1.In the production process, it is necessary to strictly abide by relevant laws, regulations and standards to ensure product quality and safety.
2.For materials such as high-density sponge and bulletproof nylon cloth used, it is necessary to choose products with reliable quality and ensure that the materials have relevant certifications.
3.When installing electronic equipment and locks, it is necessary to ensure their stability and reliability to prevent safety accidents caused by equipment failure.
4.During the commissioning process, the performance of the door should be comprehensively tested to ensure that it meets the design requirements and safety standards.
5.During transportation, special attention should be paid to protecting the edges and surfaces of the door against bumps and scratches. At the same time, it is necessary to ensure that the packaging is firm to prevent accidents during transportation.
6.During use, the soft pack safety door should be regularly inspected and maintained to ensure that it remains in good working condition for a long time. At the same time, the problems found should be dealt with and repaired in a timely manner.