The process of using the oximeter for the little nurse

Mondo Health Updated on 2024-02-29

Small** oximeter use process.

1. Overview of oximeter.

An oximeter is a medical device used to monitor the oxygen saturation of the human body, which is widely used in places such as hospitals, homes, and stadiums.

It assesses the body's respiratory function by measuring oxygen saturation in the blood.

The oximeter is a portable, easy-to-operate blood oxygen monitoring device, and this article will introduce its use process in detail.

2. Preparations.

Before using a small ** oximeter, you need to do some preparations.

1.Make sure the oximeter is well powered: Check the power level of the oximeter, if it is low, it should be charged first.

2.Check the integrity of the sensor: The sensor is an important part of the oximeter and needs to be sure that it is intact.

3.Prepare for recording** or software: When using an oximeter, you need to record the value of your blood oxygen saturation, you can use a paper record** or related software.

3. Wear the oximeter correctly.

Wearing an oximeter is a critical step in accurate measurements.

1.Choose the right finger: In general, you can choose the middle, ring or little finger, and it is not advisable to choose a finger that is too thick or too thin.

2.Clean your fingers: Wash your fingers with warm water and soap to make sure they are clean and free of dirt.

3.Wearing the sensor: Point the probe of the sensor at your finger and press down gently to make sure the sensor fits snugly with your finger.

Fourth, boot and setup.

Proper boot and settings can make the oximeter work properly.

1.Press the power button: Press and hold the power button until a small ** oximeter logo appears on the screen, indicating that the oximeter has been turned on.

2.Set parameters: According to the need, you can set the alarm range, display unit, brightness and other parameters of the oximeter.

3.Wait for the self-test to complete: The oximeter will perform a self-test, and relevant information will be displayed on the screen, and you can start using it after the self-test is completed.

5. Start measuring.

The correct measurement method can give accurate oxygen saturation data.

1.Be quiet: During the measurement, try to be as quiet as possible and avoid talking or moving to interfere with the measurement results.

2.Make sure the finger is not compressed: During the measurement, the finger should not be compressed to avoid affecting the measurement of blood oxygen saturation.

3.Wait for the measurement results: After the oximeter starts the measurement, the oxygen saturation value will be displayed on the screen, and the result will be available in a few seconds.

6. Record and analyze data.

Recording and analyzing measurement data helps to understand the health of the human body.

1.Record data: Use a paper record** or related software to record the measured oxygen saturation value.

2.Analyze the data: Analyze the recorded data to observe the changes in blood oxygen saturation and understand the health status of the body.

Related Pages