Whether it is wild fishing or black pit, there may be a phenomenon that the float drifts but does not hit the fish, and there are many possible factors, mainly concentrated in the drifting, fishing rig and bait. It can also be caused by fish, such as slippery mouths, light mouths, and trash fish hooks. For the phenomenon of frequent rod failure to hit the fish, it is necessary to make adjustments one by one, and there will always be an improvement effect, after all, there is a mouth, and there are naturally fish in the den. 
1. The drift is not actually the float itself, but the state of the fishing rig in the water, especially the hook bait, subline and sinker. Through different drifting methods, or adjusting the height of the fishing purpose to change the different states of the fishing rig in the water, the purpose is to achieve the effect of convenient bait for fish, but the drift phase transmission is more timely and sensitive. For bottom fishing, there is a contradiction between the convenience of baiting and the convenience of drifting. The more blunt it is, the easier it is for the demersal fish to get baited, but the more untimely the drift is delivered. The more spiritual, the more timely the drift phase transmission, but the hook bait is more difficult to enter, because the hook line tightly pulls the bait when fishing the spirit, the hook bait is not easy to be sucked into the mouth of the fish, and the hook line is easy to block the fish's mouth. 
After the drifting, it is necessary to find the mouth, so the more scientific method of drifting is to adjust the drift with bait, when you know the weight of the bait and the hook, you can judge the effect of the fishing rig under the water according to the increase or decrease of the fishing purpose. For example, if you don't hang the wire to adjust 8 meshes, there are 6 meshes left after the hanging strand line, which means that the weight of the double hook is 2 meshes. Then hang the bait and weigh it, assuming that there are 2 meshes left in the float, then the weight of the double hook is 4 mesh. The most intelligent time to fish the bottom is to fish a little more than 2 mesh, and the bait has just touched the bottom slightly. The process of increasing the fishing mesh is the process of becoming dull, from the bottom of the bait to the bottom of the lying bottom, the upper bait also touching the bottom, lying on the bottom, and finally the hook bait is completely lying on the bottom. According to the characteristics of the fish, it is reasonable to find the state of high medium fish rate. 
At this time, the drift has not been completed, and it can only be said that the fish mouth has been preliminarily found. As the fishing time continued, the catch rate was found to be much lower. At this time, you can pull down the floating seat to see if the tuning is still 8 mesh, and it is very likely that it has become 7 or even 6 mesh, which is the result of the draft of the fishing rig. The solution is to trim a little more lead skin, adjust it back to 8 mesh, and then find the mesh with a higher catch rate just now, so that you can ensure the hit rate. If you have just changed to a different line and bait, then the weight of the hook bait has changed, it is best to weigh the bait and hook weight, and find the state of high and high fish rate again. 
Second, the fishing group will affect the quality of the mouth, especially the thickness of the line, this phenomenon may not be very obvious when fishing for big fish, but it will be very obvious when fishing for crucian carp. Even in the spring and autumn when crucian carp forage extremely vigorously, 1It is also difficult to catch crucian carp with only about 50 grams. However, if you replace a thinner strand with a thin strand, such as 06 strands, there will be a qualitative leap in the mouth of the fish. The thickness of the strand will block the mouth, and the foreign body sensation is too strong when the crucian carp eats the hook, so it gives up eating, and although the drifting phase is definitely not hit by the fish. Whether the sub-line is blocked or not is also related to the drifting, and if it is the drifting method of the sub-line lying at the bottom, the thickness of the sub-line is not a big problem. In addition, the size, softness and hardness of the bait will also affect the eating mouth of the fish. Fish have the characteristics of eating soft rather than hard, and if the sticky bait can be used to the end, then it is not appropriate to use dry and hard bait. 
Especially when using hard bait such as corn kernels, wheat kernels, and rubber band pellets, be sure to move the bait to the place where the hook bends, and the hook tip is fully exposed to ensure a high rate of catching fish. Please pay attention to the collection and like, update on time every day, thank you fishing friends!