Settling plate Settling plate is an important engineering equipment used to monitor the settlement and deformation of foundations. In the process of lengthening the settling plate, it is usually connected by threaded connection. First of all, we need to choose the right settling plate to ensure that its length and diameter meet the engineering requirements. Then, compare the two settling plates to make sure they have the same thread size. Next, we can start the lengthening operation. First, apply an appropriate amount of sealant to the joint part of the settling plate to prevent leakage and loosening. Then, align the two settling plates and bolt them together. Finally, we can use a measurement elevator to measure the length of the settling plate to ensure that it meets the engineering requirements.
In the process of lengthening the settling plate, the following points need to be noted. First of all, make sure that the threads of the two settling plates are the same to avoid a weak connection or leakage. Secondly, when applying sealant, it should be applied in an appropriate amount to prevent too much sealant from affecting the normal use of the settling plate. Finally, when using the measurement altimeter, it is necessary to ensure that the measurement position is accurate to avoid excessive errors affecting the measurement results.
By adopting the threaded connection mode to extend the settlement plate, the extension work of the settlement plate can be completed conveniently and quickly. At the same time, in the process of lengthening the settlement plate, it is necessary to pay attention to the relevant engineering specifications and operating procedures to ensure the quality and safety performance of the settlement plate.