DescriptionThe PSX 60 Epoxy Adhesive Kit contains adhesive resin, hardener, mixing spatula, and assembly instructions. Adhesive resin (parta) is a black paste containing sand filler and conductive fibers. The adhesive hardener (part B) is an off-white paste. The adhesive of this mixture is black. PSX60 is a two-part epoxy siloxane adhesive used to permanently bond tapered joints on Quick Lock or glass fiber reinforced pipes and fittings. The PSX60 can be used to connect most epoxy and phenolic piping systems. Before instructions, read all toxicity, precautions, and first aid information below. Before mixing the adhesive, make sure that the bonding surface is properly treated and that it is clean and dry. Open the resin and hardener container. Use a stirring spatula to scrape all the hardener into the container. Mix the resin and hardener with a spatula for at least 60 seconds. Scrape off the sides, bottom, and lid of the resin container from time to time to allow all hardener to enter the mixture. Never attempt to split the kit or heat the hardener. The resin and hardener have been packaged in the correct proportions for optimal adhesive performance. Apply an even layer of mixed adhesive to both bonding surfaces, then pull the parts firmly together. Detailed fitting assembly instructions can be found in the Quick Lock Installation Instructions and the Bell X Spigot Installation Instructions. Pot life and cure time are ideal for use temperatures below 180°F (82°C) and pressures below 150 psi (103 MPa), the PSX 60 bonding can be put into service with ambient temperature curing, as shown in the table. However, it is highly recommended to use an external heat source to force scraping off the adhesive. The adhesive and adhesive surface should be heated to 70 °F (21 °C) before mixing and applying. The adhesive can be forced to cure using a hot plate approved by the NOV fiberglass system. The table also shows the service life (operating time) of the adhesive at different temperatures. The pot life is the time from the initial mixing of the resin and hardener to the time when the adhesive in the container begins to thicken and is no longer usable. For expected use temperatures above 180°F (82°C) or operating pressures above 150 psi (103 MPa), or when installing the system at ambient temperatures below 40°F (5°C), the bonded joints must be cured using an external heat source. It is recommended to use a NOV fiberglass system approved electric blanket for heat curing. Thermal curing can be performed at any time after bonding and before testing or use. When the adhesive is a stationary liquid or after it has gelled into a solid, heat can be applied immediately after the bonding is performed. The recommended minimum curing time is 30 minutes for 1 to 6 inch pipes and 45 minutes for 8 to 16 inch pipes. Even after the adhesive has cured at ambient temperature, heat curing enhances the chemical cross-linking of the adhesive, improving the strength, heat resistance, and corrosion resistance of the adhesive. When used in fire service, all joints must be forced to cure using an external heat source, regardless of ambient temperature.
First Aid: In case of contact with eyes: Immediately rinse eyes with plenty of water for at least 15 minutes. Call the doctor. **Wash with soap and water**. Clothing: Remove contaminated clothing and wash it before use. Inhalation: Transfer to fresh air. Give oxygen or artificial respiration if necessary. Ingestion: If the catalyst is ingested and the patient is conscious, give plenty of water or milk to drink. Do not induce vomiting. Call the doctor. If resin is swallowed, 100 grams (about pounds) of activated carbon slurry is given in water.
Creative Inspiration Center