1. Problem diagnosis
The toilet bowl is constantly filled with water is usually caused by the failure of the internal parts of the tank. In general, there may be a problem with the following parts:
1. Failure of float or floating bucket: Control the water level, if it fails, the water will continue to flow.
2. The inlet valve is damaged: Controls the flow of water to fill the tank, and if it cannot be closed, the water will be continuously injected.
3. Overflow pipe problem: If the water level is too high, the water will flow out through this pipe.
4. The sealing ring is worn: If the sealing ring connecting the water tank and toilet bowl is worn, it will cause water leakage.
2. Prepare tools
1. A screwdriver.
2. pliers. 3. Replacement of internal parts (if necessary).
4. Rubber gloves.
5. Cleaning cloth.
3. Repair steps
1. Turn off the water source.
Close the water supply valve that connects to the back or side of the toilet.
2. Empty the water tank.
Flush the toilet to drain the water in the tank.
3. Check the float or bucket.
Open the lid of the tank and check if the float or bucket floats normally. If it cannot be floated or the water level adjustment screw is loose, adjust it to the appropriate position or replace it with a new float bucket.
4. Check the water inlet valve.
When the float or bucket is normal, check whether the inlet valve can be closed. If the inlet valve is jammed or damaged, it may need to be replaced with a new inlet valve.
5. Check the overflow pipe.
Make sure that the water level of the overflow pipe does not exceed the top of the pipe. If the water level is too high, adjust the water level control screws of the float or float bucket.
6. Check the sealing ring.
If the front parts are all normal, check the seal at the bottom of the tank for wear or looseness. Replace the seal if necessary.
7. Replacement parts.
If you need to replace internal parts, purchase a replacement part for the corresponding model. Replace according to the product instructions.
8. Test the repair effect.
After the replacement or adjustment is complete, open the water supply valve and let the tank refill. Observe whether the tank can stop filling at the appropriate water level and check for water leakage.
9. Final inspection.
Once you have confirmed that the toilet is working properly, clean up the tools and the site to make sure there are no missing parts or tools.
4. Frequently Asked Questions
1. The water flow in the water tank is non-stop: Inspect floats, buckets, and inlet valves, and adjust or replace them if necessary.
2. The water tank is not filled with water or fills slowly: Clean the filter at the water inlet and check for blockages.
3. The overflow pipe overflows: Adjust the float to the appropriate water level to prevent the water level from being too high.
5. Precautionary measures
To avoid future repairs, regularly check that the components inside the toilet tank are working properly, and clean the water inlet and strainer to ensure a smooth flow of water. If any abnormalities are detected, early repairs can avoid greater losses and inconveniences.
The problem of a toilet bowl filling constantly filling can usually be solved with simple troubleshooting and parts replacement. Although it may seem complicated, most home users can repair it themselves using basic tools. If you encounter more complex problems or repairs that are beyond your ability, you should contact a professional plumbing repair service in a timely manner. Remember, regular maintenance and inspection of the toilet bowl can effectively prevent problems and ensure the comfort and hygiene of home life.