OneHow to use the ball valve:
Switch operation
The switch is achieved by rotating the sphere, usually 90 degrees, but there are also cases of 180 degrees or 360 degrees;
Intermittent Operation:
Typically used for fluid control;
All-through operation:
Fluid flow is guaranteed by opening the ball valve completely
Cut-off Actions:
Block the flow of fluid by closing the ball valve completely;
Turn it on or off gradually
Adjust the amount of fluid gradually.
IIBall valve installation points:
1. The ball valve should be installed in the lowest part of the pipeline in order to empty the air and water in the pipeline
2. The ball valve should be installed in an easy-to-operate location for maintenance and replacement
3. The flange connection of the ball valve should be connected according to the standard of the pipeline
4. The flange connection of the ball valve should be matched with the flange connection of the pipeline and sealed well.
IIIBall valve maintenance tips:
Ball valve leaks:
Check the sealing condition of the ball valve, if there is a problem with the O-ring, it should be replaced in time;
Ball valve clogged:
Check whether there are impurities in the pipeline, clean the pipeline, replace the ball valve;
Ball valve leakage:
Check whether there is air leakage in the ball valve itself, you can replace the seal or adjust the valve;
Ball valve movement is not flexible:
Check that the ball valve is moving smoothly and can add lubrication or replace the seat.
Detersen reminds that it is important to note that the ball valve should be closed and the fluid in the pipe should be drained before performing a ball valve service.
Detersen ball valves