In daily life, we often use a variety of smart devices, among which the smart water cup is a very practical device. However, as the use time increases, the battery of the smart cup may be low on power, and the battery needs to be replaced. So, how do you replace the battery of a smart water cup?The following is a detailed introduction to the steps to replace the battery of the smart water cup.
1. Preparations.
Before we start replacing the battery, we need to make the following preparations:
1.Prepare a new battery suitable for the smart water cup, usually the battery of the smart water cup is removable, you need to buy the corresponding model;
2.Prepare a screwdriver or a suitable disassembly tool to facilitate the removal of the bottom of the cup
3.Prepare a clean cloth to make it easier to wipe off dust and dirt from the inside of the drinking glass.
2. Disassemble the old battery.
First of all, we need to remove the bottom of the smart water bottle. The specific steps are as follows:
1.Unscrew the bottom set screws, usually there will be a few small screws to hold the bottom in place;
2.Gently pry the bottom lid open with a screwdriver, there may be snaps to pay attention to;
3.Find the location of the old battery, in general, the position of the old battery at the bottom**;
4.Use a screwdriver to gently pry up the old battery, being careful not to use too much force to avoid damaging the board.
3. Install a new battery.
Before installing the new battery, we need to place the new battery in the corresponding position and then follow the opposite steps to install it:
1.Gently place the new battery in place;
2.Close the bottom lid and tighten the set screws
3.Check if the water cup is working properly, and if it doesn't, check if the circuit is connected correctly or if the battery is installed correctly.
4. Precautions.
In the process of replacing the battery, the following points need to be noted:
1.When purchasing a new battery, you must pay attention to the model and brand of the battery, so as to avoid the inability to install or use the battery normally due to the purchase of an unsuitable battery
2.Be careful during disassembly and installation to avoid breaking the buckle or damaging the circuit board due to excessive force
3.Be sure to turn off the power of the smart cup or remove the built-in rechargeable battery before replacing the battery
4.After the installation is completed, check whether the water cup is working properly, if it is not working properly, you can check whether the circuit is connected correctly or whether the battery is installed correctly.
That's all there is to replace the battery of a smart water cup. It should be noted that if you are not familiar with the disassembly and installation process, it is recommended to seek the help of professional technicians to avoid unnecessary losses and safety problems. At the same time, in order to avoid the occurrence of low battery power of the smart water cup, it is recommended to check the battery condition regularly and replace it in time.