The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force

The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force

In the troubleshooting analysis of the cable displacement sensor, due to the limitations of the displacement sensor due to the installation control, the compact aluminum alloy shell was specially customized, which made the appearance more exquisite and more beautiful. Because the company's displacement sensor has been working in a high-temperature environment for a long time, the use of conventional steel rope often occurs in the case of wire breakage, and the use of imported wire rope from the United States is more wear-resistant and not easy to break.

The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force

The cable displacement sensor has a wide range of electrical adaptability, with a high capacity of 30V power supply voltage acceptance, and a built-in two-stage voltage regulator and filter circuit to ensure that the output signal is stable, and at the same time, it is convenient for users to directly use the industrial power supply. The power input terminal is equipped with surge and reverse polarity protection, which solves the loss caused by overcurrent and overvoltage. Improper installation or use is very prone to failure, and the wear resistance of the internal resistor will be relatively reduced after long-term use, resulting in a decrease in the measurement accuracy of the displacement sensor.

The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force

When the magnetic field is intersected by the magnetic field set on the waveguide and the active magnetic ring that acts as a position change, due to the magnetostriction, a strain mechanical wave pulse signal will be generated in the waveguide, and this strain mechanical wave pulse signal is transmitted at a fixed sound speed and is quickly detected by the electronic room. The displacement sensor adopts a gear ratio reduction system inside to stabilize the tension of the wire rope, and the pull wire is stable and reliable when it is pulled out or retracted, and the automatic rebound mechanism adopts imported stainless steel scroll spring, which has strong elasticity and fatigue resistance, and the strict spring fatigue test reaches 1000000 times without loss.

The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force

The pull wire displacement sensor uses a gear ratio reduction system to stabilize the pulling force