Product Description:
PT-RGB1608 16-A is a matrix switcher that supports 16 tones** signal input and 8 16 tones** signal output.
The 16 input RGB signals can be switched to any one or more channel outputs synchronously or asynchronously with the stereo audio signal.
High-performance image processing and signal long-distance transmission distortion gain compensation technology are used to make the image signal transmit high-fidelity output over long distances.
With RS-232 communication interface and network interface, it is convenient to connect with computers, remote control systems or various remote control devices.
Support 16 tones** signal input, 8 16 tones** signal output.
*The signal input and output terminals adopt BNC interface;
The input and output terminals of the audio signal adopt 5-bit 38mm Phoenix connector;
Support fast switching operation
Programmable logic display circuit, arbitrary interactive switching;
Support tone** synchronization or separation switching function;
Support channel switching permission setting, audio channel switching permission can be managed separately and independently;
Supported signal types are: RGBHV, RGBS, RGSB, RSGSBS high-definition television (HDTV), component**, S-video, composite**;
450MHz (-3dB), full load bandwidth;
Signal long-distance transmission distortion compensation technology;
The types of audio signals are: stereo (balanced or unbalanced);
The volume of each audio output channel can be adjusted independently
It has the function of power-down memory, with the function of power-off on-site protection;
Support RS-485 extended keyboard operation;
It has 2 RS-232 communication interfaces
It has 1 network interface, which can be remotely controlled through Ethernet, and supports 8 users to connect at the same time
Built-in international power supply.
Standard 19-inch cabinet mounting: 7U metal chassis.
Category PT-RGB1608 16-A
*。Gain 0 dB
Bandwidth 450MHz (-3dB), full load.
0 -10mhz @ 0.1db
0 -100mhz@+0.6db
Multichannel-to-one-channel crosstalk and -56db@10m, -40db@100m, differential phase i 0s<128 degrees, 358mhz
Differential phase error 01 degree, 358-4.43mhz
Differential gain error 01%, 3.58-4.43mhz
Propagation delay 5ns (1ns).
Switching speed 200 ns (long time).
Signal Type RGBHV, RGBS, RGSB, RSGSBS, High Definition Television (HDTV), YCBCR YPBPR Component Video, S-Video, Composite (CVBS).
*Input. Interface: BNC female interface.
Signal strength 1vpp component**or y, composite in S-video**;
0.3VPP component** in CB PB or CR PR, C in S-video
Small level 05vpp / 2.0VPP (analogue signal).
Impedance 75
Return loss -30db@5mhz
DC bias error 15mV
*Output. Interface: BNC female interface.
Small level 05vpp / 2.0VPP (analogue signal).
Impedance 75
Return loss -30db@5mhz
DC bias 5mV
Synchronization signals. Input Output type RGBHV, RGBS, RGSB, RSGSBS, input level 05v- 5.0vpp,: 4.0vpp normal
Output level AGC-TTL: 5vpp, unterminated
Input impedance 510;1-8 channels optional 75
Output impedance 75
Polarity Positive or negative (exactly as input).
Audio signals. Input and output interface 5-bit 38mm Phoenix.
Gain 0 dB
Frequency response 20 Hz 20 kHz, total harmonic distortion + noise 003% @1 kHz (at rated voltage).
Signal-to-noise ratio (SN) 90dB
Stereo Resolution: >80dB @ 1 kHz
Common rejection ratio (CMRR) >75dB @: 20 Hz 20 kHz
Signal type Stereo, balanced or unbalanced.
Impedance Input: >10 K (balanced or unbalanced).
Output: 50 (unbalanced), 100 (balanced).
Input level +195dbu, (balanced or unbalanced).
Output level +195dbu, (balanced or unbalanced).
Gain error 01db
RS-232 control interface.
Serial control interface RS-232, 9-pin female D-connector.
Baud Rate & Protocol Baud Rate: 9600, Data Bits: 8 Bits, Stop Bits: 1, No Parity Bits.
Serial control port structure 2 = tx, 3 = rx, 5 = GND
keyboard control interface.
Control interface 4-pin phoenix.
How to use It is used in conjunction with the extended keyboard PT-MCP100.
Control port structure +5V=DC5V, = data+, =data- GND = signal ground.
Ethernet control interface.
Ethernet control interface RJ-45 female interface.
Ethernet Control Protocol TCP IP
Ethernet control rate adaptive 10m or 100m, full-duplex or half-duplex.
Specification. Power supply 100VAC 240VAC, 50 60 Hz, international adaptive power supply.
Temperature Storage and use temperature: -20 70 °C
Humidity Storage and use humidity: 10% 90%.
Dimensions (mm) 483L x 290W x 310H
The weight of the product is about 7kg
Power consumption 25W
Mean time between failures of 30,000 hours.
Warranty: 1 year free warranty, lifetime maintenance.