The correct way to water flowers in pots The secret of letting plants drink enough water?
Soak pot watering is a very effective way to provide water to plants, especially for potted plants. This method allows the roots of the plant to fully absorb the water, resulting in better growth. So, how to properly use the dipping pot method to water flowers?Let's take a closer look at this approach.
1. Preparations.
1.Choose the right potter: Choose one that is deep enough to ensure that the roots of the plant can be fully submerged in the water. At the same time, it is necessary to choose a basin with more drainage holes to facilitate the discharge of excess water.
2.Prepare clean water: Use clean water, which can be tap water or filtered water. Avoid using water that contains chemicals or impurities.
3.Remove media from plants: Gently remove the top layer of media before placing the plants in the potting pot to avoid flushing the media into the potting vessel during the dipping process.
Second, the operation of soaking basins.
1.Place the potter in the right position: Place the potters on a stable flat surface so that they do not tip over or slip during the dipping process.
2.Potting the plants: Carefully place the plants in the potting, making sure the roots are completely submerged in the water. If the pot is large, you can gently shake the animals and plants so that they are evenly distributed in the pot.
3.Wait for soaking: Allow the plants to soak in water for 10-15 minutes, making sure the roots are adequately absorbing the water. At the same time, observe the drop in the water level and replenish the water in time to maintain the water level.
4.Remove the plants: Once soaked, gently absorb the moisture from the surface of the plants with a paper towel and move them back into the pot.
3. Precautions.
1.Do not over-soak: Soaking for too long may cause the plant to absorb too much water, affecting growth. Therefore, it is necessary to control the soaking time and avoid excessive soaking.
2.Pay attention to the water level: During the soaking process, it is necessary to observe the changes in the water level at any time to avoid the water level being too low or too high. At the same time, pay attention to whether the drainage hole is unblocked, so as not to suffocate the plants due to excessive water accumulation.
3.Keep the water at the right temperature: Too much or too low water temperature can cause damage to plants. Therefore, it is important to keep the water temperature appropriate and avoid direct contact with the plants with excessively cold or hot water.
4.Avoid the use of chemical fertilizers: Do not dissolve chemical fertilizers directly in water during the soaking process. Otherwise, it may cause harm to the plants or contaminate the water source.
5.Check the pots regularly: Check regularly whether the drainage holes of the pots are unblocked to avoid rotting the roots of the plants due to blocked drains. At the same time, it is also necessary to wash the basin regularly to keep it clean and hygienic.
Through the introduction of the above steps, I believe you have mastered the correct way to water flowers by soaking pots. This method not only provides sufficient water to the plant, but also helps the plant to absorb nutrients better and promote its healthy growth. Of course, different plants may have different water needs and adaptations, so it is necessary to adjust and adapt to the specific situation in practice. Wishing your plants a strong growth!