In fact, if you don't use a precision filter or dryer. This will lead to impurities, oil and water in the quality of the compressed air. So what are the hazards of poor compressed air quality?
1.The moisture and impurities contained in the compressed air lead to the phenomenon of stuck, pause, and inadequate stroke of pneumatic components and equipment, resulting in a large number of defective products.
2.Poor compressed air quality leads to increased equipment failures and downtime costs, which in turn increases manufacturing costs.
3.Poor compressed air quality leads to damage to pneumatic components and increases maintenance costs.
4.Poor compressed air quality leads to a shorter service life of pneumatic equipment.
The above is a summary of the harm caused by poor compressed air quality, so if you want to improve the production efficiency of the plant. When purchasing a screw air compressor, it is necessary to configure a dryer and a precision filter.
Read more: What to pay attention to when installing a precision filter.
Some customers inquire about what should be paid attention to when installing precision filters?Precision filter is used to deal with impurities to make the compressed air more clean and tidy, I believe that many users do not know how to install, the following will be explained for you.
1.When installing, you should first familiarize yourself with the instruction manual of this product and confirm the installation location of the productPrecision degreasing and deodorizing filters should be equipped with corresponding filter driers.
2.The interface of the filter drier is a pipe thread or flange, and the connection should maintain its sealing performance to avoid pinhole leakage and cause deviation. It is important to keep the filter installed vertically, leaving enough space under the filter to maintain the filter and the automatic drain valve.
3.Generally, the precision filter should be installed at the outlet end of the air storage tank, and the effect is better at the position where the compressed air temperature is close to the outside temperature.
4.In order to make it easier, it is not necessary to cut off the pressurized air system during service, but it is possible to isolate the filter from the system and reduce the pressure. At the same time, it should be ensured that a gas release valve is installed between the two isolation valves, and the pressure in the pipeline should be reduced to atmospheric pressure during maintenance. If compressed air with a final filter is not permitted in some applications, a second filter should be installed on the bypass line.