The assembly method of the steel strip of the new energy battery pack is as follows:
1.Preparation: Before you start assembly, make sure you have the tools and materials you need, including steel belts, wrenches, screws, and nuts.
2.Positioning and fixing: According to the design and specifications of the battery pack, place the steel strip in a suitable position. Make sure there is a proper gap between the steel strip and the battery module to ensure the installation and heat dissipation of the battery pack.
3.Set screws: Use a wrench and screws to secure the steel strap to the battery pack. According to the design requirements, fix the screws one by one and tighten them appropriately to ensure that the steel strip is tightly fixed to the battery pack.
4.Adjustment and inspection: After completing the fixing, check the position and tightness of the steel belt. If necessary, fine-tuning and adjustment can be made to ensure the stability and safety of the steel belt.
5.Maintenance: Regularly check the condition of the steel belt to ensure that it is not damaged or loose. If a problem is found, it should be repaired or replaced in time.
Please note that the above is a general assembly method and the specific steps may vary depending on the battery pack design. Before assembling the steel strip for new energy battery pack, it is recommended to refer to the relevant product manual or consult the manufacturer for accurate assembly guidance. At the same time, ensure that the relevant safety operating procedures are followed during the assembly process to ensure personal safety and assembly quality.