Metal AB adhesive is an efficient and fast metal adhesive, but in the process of use, sometimes there is a phenomenon that is not fully cured. This may be due to the following reasons:
Improper operation: When using metal AB glue, it is necessary to carry out the correct operation according to the requirements of the manual. If there is an error in the operation process, such as improper mixing ratio, uneven mixing, etc., it may cause the glue to not be fully cured.
The temperature is too low: the curing speed of metal AB glue is greatly affected by temperature. If the ambient temperature is too low, it may cause the glue to cure slower or even not fully cured. Therefore, when using metal AB adhesive in a low-temperature environment, it is necessary to take heating measures or choose a low-temperature curing glue.
Improper treatment of the adhesive surface: The bonding effect of metal AB glue is affected by the treatment of the adhesive surface. If the adhesive surface is not cleaned or there are impurities such as oil and dust on the surface, it may affect the adhesion and curing effect of the glue. Therefore, it is necessary to properly treat the bonding surface before bonding.
Glue quality problems: The quality of metal AB glue is also an important factor affecting the curing effect. If the purchased glue is of faulty quality, such as impure composition or expired, etc., it may cause the glue not to cure completely. Therefore, when buying metal AB glue, you need to choose a reputable brand and manufacturer.
To sum up, the reason why Huirui metal AB adhesive is not fully cured may be improper operation, too low temperature, improper treatment of the adhesive surface or glue quality problems. When using metal AB glue, it is necessary to pay attention to the correct operation method, appropriate curing temperature and adhesive surface treatment, and at the same time choose the best metal AB glue.