In daily life, we often encounter the problem of a large waistband of our pants. Sent to a tailor's shop, usually the tailor will use scissors to cut off a piece of the waistband of the pants. However, if the waistband becomes too tight after cutting, the pants may not fit well. Today, I'm going to share a simple and practical way to cinch your waist without leaving a trace, so that you can easily solve this problem.
The method is very simple, the pants have such a belt buckle, put the pants behind the belt buckle,
From here, the needle is picked up.
Then pick up in the same way on the corresponding side.
When you sew, you should pay attention to the height of both sides to be the same, and keep parallel first, so that it can be smoother and the effect will be better.
Sew to the very top and gently tighten the thread.
After tightening, the sewn place will be automatically retracted, and it is very flat, and the thread can not be seen.
The last step is to stitch a few more stitches to fix the bulge and prevent him from slumping
Just cut the thread and you're good to go.
In this way, the waist circumference can be reduced by 2-3 cm, which is equivalent to an inch. If the pants are still large, you can sew them again under the belt buckle on the other side.
This method is not only simple and convenient, but if you feel that the waistband of your pants is tight, you can remove the thread. Isn't it very practical?
This traceless waist tucking technique is not only easy to learn, but also very practical. With this method, you can easily adjust the waist of your pants to make them fit more comfortably. Never worry about pants that are too big or too loose again. Hopefully, this tip will help you solve the little worries of your daily life and make you feel more confident in wearing your favorite pants.