The correct way to install a Y-filter is as follows:
1. First of all, determine the appropriate position of the Y-type filter. In general, Y-filters should be installed at the entry point of the piping system in order to capture particles and impurities in the fluid.
2. Before installation, make sure to close the valves of the relevant parts to avoid fluid flow.
3. Clean and prepare the pipeline to ensure that there is no dirt and impurities on its surface.
4. Using a suitable tool, unscrew the pipe joint so that the Y-type filter can be installed on the pipe.
5. Before connecting the filter, the thread on the pipe interface should be coated with appropriate sealant or lubricant.
6. Align the connecting part of the Y-type filter with the pipe interface and insert it into the pipe slowly.
7. Use appropriate tools to tighten the Y-type filter and the pipe interface to ensure that the connection is tight and to avoid water leakage.
8. Reopen the valve and allow the fluid to flow.
9. Check whether there is water leakage in the connection part to ensure that the filter can work normally.
Please note that these are general installation steps only and may vary depending on the filter model and piping system. Therefore, before installation, it is best to refer to the installation instructions of the Y-type filter or contact the ** supplier to understand the specific installation requirements and steps.
Detersen Y-type filter