How to cut rock wool insulation board.
1. The rock wool insulation board needs to be cut by a special rock wool cutting machine. 2. Cutting rock wool insulation board requires the use of a special rock wool cutting machine for cutting, because it has high machinability.
1. Use a rock wool cutting machine to thicken the wall: spray a layer of flake material (such as quartz sand, etc.) on the wall, and then wipe the clay and asphalt mixture with sawdust; If the cutting method is made by waterjet cutting or wire wire sawing machine, the cutting area can be effectively reduced.
2. Use a high-pressure drill bit to clean and disinfect indoor and outdoor walls and grounds: add the residual calcium oxide solution to the water to decompose it into harmless water droplets and then rinse it off with water, and then transport it to the outdoor equipment through the pipeline to clean up the dust and achieve the purpose of cleaning and hygiene.
3. For special requirements:
1) Special environmental protection equipment must be selected, and the quality of the equipment is reliable.
2) No matter what kind of material the rock wool insulation board must undergo professional safety training, operate in strict accordance with relevant regulations, and do a good job of relevant records and data reports.
4) Any accident caused by the inability to use rock wool melting cutting tools should be reported to the relevant departments in time and necessary safety measures should be taken.
How to cut rock wool insulation board.
Rock wool insulation board is a new type of insulation material, which can be used to make walls or floors in buildings. When cutting, you need to pay attention to safety and environmental protection issues: wear protective equipment when cutting, such as gloves, goggles, etc.; It can also be operated with professional tools such as waterjets or pliers.
Pay attention to the following points when using rock wool insulation board:
The process of cutting rock wool insulation board will lead to the production of corrosive gases in local tissues, which is harmful to human health. Therefore, cleaning and disinfection should be carried out before dealing with this problem. Replace contaminated products regularly to protect yourself.
If you need fast, efficient and safe plant removal services, Barros has the ability to remove hazardous equipment and tanks with its waterjet cutting technology. As well as the ability to treat residual hazardous chemicals and hazardous waste on site after dismantling, the specific steps should be determined according to their actual needs during the cutting process, and adjusted in accordance with relevant regulations. At the same time, care should be taken to prevent damage to equipment and other facilities.