1. [Multiple choice questions] The "Special Equipment Safety Law of the People's Republic of China" stipulates that if the use of special equipment is not registered in accordance with the regulations, it shall be ordered to make corrections within a time limit; If the correction is not made within the time limit, it shall be ordered to stop using the relevant special equipment and shall be fined below () or above. （ ac ）
a. 10,000 yuan.
b. 20,000 yuan.
c. 100,000 yuan.
2. [Multiple choice questions] The "Regulations for the Safety and Technical Supervision of Special Motor Vehicles in the Field (Factory)" stipulates that regular inspections shall be carried out in () during the use of mobile vehicles. （ cd ）
a. Place of sale.
b. Place of manufacture.
c. Place of use.
d. Place of use registration.
3. [Multiple choice questions] The following () shall not be parked. （ bd ）
a. Within 50m from the gas station, the door of the fire garage and the fire hydrant.
b. Lots within 15m from intersections, crossings, turns, tunnels, dangerous lots, factories and warehouses.
c. The longitudinal slope is greater than 15%.
d. When there is an obstacle on one side of the road, the opposite side and the length of the obstacle are within 20m at both ends of each end.
4. [Multiple choice questions] The basic tasks of accident emergency response are mainly (). abcd ）
a. Preliminary understanding of the accident situation.
b. Guide the masses to protect and organize the evacuation of the masses.
c. Control the source of danger.
d. Rescue victims.
5. [Multiple choice questions] The direct causes of the accident include (). abc ）
a. The unsafe state of the equipment.
b. Unsafe behavior of people.
c. Matching of people, objects and environment.
d. Management reasons.
6. [Multiple choice questions] The following () situations may lead to overturning. （ abcd ）
a. The action of lifting heavy objects is too fast.
b. Sudden braking.
c. Crossing the slope.
d. Turn on a slope.
7. [Multiple choice questions] Attention should be paid to the use of forklifts (). abcd ）
a. Precautions in the instruction manual.
b. Warning. c. Warning.
d. Identification. 8. [Multiple choice questions] The stability test of the forklift includes: () ABC).
a. Longitudinal stability and lateral stability when the forklift is fully loaded and palletized.
b. Longitudinal stability of the forklift when driving with full load.
c. Lateral stability of the forklift when driving without load.
d. Stability of forklift when climbing.
9. [Multiple choice question] The lifting of the forklift mast is weak, which may be due to (). acd ）
a. The gear of the oil pump and the pump body are worn excessively, and the gap is too large.
b. The load is too light.
c. Oil leakage between the valve bodies of multi-way valves.
d. The piston sealing ring of the hoisting cylinder is worn and leaks.
10. [Multiple choice question] The valve mechanism of the engine is composed of (). （ abc ）
a. Valve group.
b. Valve transmission group.
c. Valve actuation group.
d. Cylinder head gasket.
11. [Multiple choice questions] The operator has the right to refuse to execute the () behavior of the management personnel of the employer. （ ab ）
a. Command in violation of regulations.
b. Forced risky work.
c. Arrange work.
12. [Multiple choice questions] The transmission pair of the circulating ball steering gear includes (). ab ）
a. Screw nut transmission pair.
b. Rack and pinion fan transmission pair.
c. Turbine worm transmission pair.
d. Worm finger pin transmission pair.
13. [Multiple choice question] The () of the pallet stacker truck must be kept complete and effective. （ abc ）
a. Brake.
b, steering gear.
c. Horn. d. Wipers and mirrors.
14. [Multiple choice questions] During daily maintenance, the correct maintenance of forklift wheels is (). abcd ）
a. Hub bolts and rim bolts should not be missing, damaged or loose.
b. Tire inflation should be within the specified range.
c. There is no abnormality in the wear of the tire tread, and there is no oil stain on the surface.
d. There should be no abnormal heating phenomenon on the rim after operation.
15. [Multiple choice questions] The operators of the special equipment user unit shall strictly implement the () of the special equipment in the operation. ad ）
a. Operating procedures.
b. Manufacturing specifications.
c. Design specifications.
d. Relevant safety rules and regulations.
16. [Multiple Choice Questions] The purpose of accident investigation and analysis is (). abc ）
a. Accurately find out the cause of the accident.
b. Prevent similar accidents from happening again.
c. Investigate the responsibility of relevant personnel.
d. Draw a clear line of responsibility.
17. [Multiple choice] CQDXX represents () (c).
a. Counterbalanced battery forklift.
b. Counterbalanced diesel forklift.
c. Reach battery forklift.
d. Pallet stacker.
18. [Multiple Choice] The "Special Equipment Safety Law of the People's Republic of China" stipulates that if a special equipment user uses personnel who have not obtained the corresponding qualifications to engage in the safety management, testing and operation of special equipment, the legal responsibility shall be (b).
a. Revoke the business license.
b. Order corrections within a time limit; If the correction is not made within the time limit, it shall be ordered to stop using the relevant special equipment or suspend production and business for rectification, and a fine of not less than 10,000 yuan but not more than 50,000 yuan shall be imposed.
19. [Multiple choice question] The "Special Equipment Safety Law of the People's Republic of China" stipulates that the user of special equipment shall, in accordance with the requirements of the safety technical specifications, submit regular inspection requirements to the special equipment inspection agency () months before the expiration of the validity period of the inspection. （ a ）
a、1b、2
c、3d、6
20. [Multiple choice question] The "Rules for the Management of the Use of Special Equipment" stipulates that the main person in charge of the special equipment user refers to the special equipment user (), and is responsible for the safety and energy conservation of the special equipment used by the unit. （ c ）
a. Chairman of the Board.
b. General Manager.
c. Actual top management.
d. Factory director. 21. [Multiple choice question] The following options belong to the actuators in the hydraulic system (). b ）
a. Oil pump. b. Oil cylinder.
c. Hydraulic valve.
22. [Multiple Choice] Any substance that can chemically react with combustible substances and play a role in combustion, is called a combustible substance. For example, (), etc. （ a ）
a. Air, oxygen.
b. Gasoline and diesel.
c. Paraffin, camphor.
23. [Multiple Choice] In the DOW method, general process hazards are the main factors in determining the size of accident damage, and () does not belong to its content. （ a ）
a. Low temperature. b. Material handling and transportation.
c. Exothermic chemical reactions.
24. [Multiple choice question] In the hydraulic transmission device of the forklift, its actuator refers to (). a ）
a. Hydraulic cylinder.
b. Relief valve.
c. Reversing valve.
25. [Multiple choice question] When the forklift is driving, the minimum ground clearance of the fork is: () c ).
a、100—200mm
b、200—300mm
c、300—400mm
26. [Multiple Choice] Forklift Parts Identification - What Forklift Parts Is This?
221.When the driver leaves the car, he should (abc).
A. Tighten the hand brake, B, cut off the circuit, C. Lock the door, D. Turn in the car keys.
222.When the driver leaves the car, he should tighten the hand brake, (b) and lock the door.
A. Hang the back gear, B cut off the power supply, C hang the forward gear.
223.After the driver is fatigued, he cannot flexibly and quickly change the driving condition to avoid obstacles according to the situation in (c). A vehicle technology B model C traffic changes, roads.
224.When the driver gets out of the car after stopping, he should first look at the front and rear of the vehicle, and open the door only if there is no vehicle (C). A: Overtaking, B will car, C approaching D, giving way.
225.True/False Drivers are strictly forbidden to work under the influence of alcohol. (a) A is true B is false.
226.Single-choice questions drivers should adhere to the "three inspections", that is, the inspection of (c).
A morning, noon, and evening repairs, b before leaving the car, during maintenance, c before leaving the car, during operation, and after receiving.
227.Multiple-choice questions drivers should do (ACD).
A. The safety equipment is incomplete or malfunctioning, and the car is not out, B. The fuel tank is not satisfied, and the car is not out, C. The brake (that is, the brake) is not working, and the car is not out, and D. The horn is not sounded.
228.True/False: When drivers drive in cold winter climates, the most susceptible areas of frostbite are the nose, cheeks, ears, toes, and fingers. (a) A is true B is false.
229.Multiple-choice questions If the driver feels tired or drowsy at work, he or she should try to (ABCD) and wait until the sleepiness has passed before working. a. Sleep for a while, b get out of the car and wash your face, c. drink some cool drinks, d. run and run.
230.In practice, drivers should use psychology to analyze, synthesize, judge, reason, and dispose of various information on the road to ensure (c) safety. A pedestrian B vehicle C driving.
231.One of the characteristics of multiple-choice driver work is that (b) has a high degree of mental concentration and is prone to fatigue driving. A short time B long time C daily d intermittent.
232.When checking or filling fuel, do not smoke or go near an open flame. (a) A is true B is false.
233.When testing the battery electrolyte, you can use an open flame to illuminate. (b) A is true B false.
234.True/False overloading will reduce the lifespan of your vehicle's tires. (a) A is true B is false.
235.True/False: The hollow shaft of the vehicle drive shaft is only used to save materials. (b) A is true B false.
236.The length of the transmission shaft of the vehicle is retractable to ensure that the transmission shaft is not disengaged and not killed under various working conditions. (a) A is true B is false.
237.A 180° change in the direction of travel of a multiple-choice vehicle is called (c).
Vehicle A: Vehicle B: Reversing, Vehicle C, Vehicle U-turn, Vehicle D: Re-route.
238.True/False: The larger the wheel base of the vehicle, the better the lateral stability. (a) A is true B is false.
239.The braking efficiency of the true/false vehicle is not affected by the road, climatic conditions, vehicle type, etc. （ b）
500.The primary maintenance of the multiple-choice field vehicle is carried out after (b) working hours.
a200 b250 c300
501.The primary maintenance of the multiple-choice field vehicle is carried out after (b) working hours.
a200 b250 c300
502.The instrument of the field car is the interface for information exchange between the field car and the driver, providing the driver with the necessary operation information of the field vehicle, and is also an important basis for maintenance personnel to find and eliminate faults. （a ）
A is true B is false.
503.The instrument of the field car is the interface for information exchange between the field car and the driver, providing the driver with the necessary operation information of the field vehicle, and is also an important basis for maintenance personnel to find and eliminate faults. （a ）
A is true B is false.
504.Multiple-choice question field vehicle instrument should have (ABC) and other characteristics.
a. Simple structure b. Good impact resistance.
c. Reliable operation The value of the dmeter can change with the change of ambient temperature.