Access control system is an important part of modern smart buildings, which can not only improve the security of the building, but also provide convenience for the people in the building. Below we will go through the steps to set up the access control system in detail.
1. Preparations.
Before installing an access control system, you need to make the following preparations:
1.Determine the needs and capabilities of the access control system, such as which doors need to be controlled in and out, what cards or passwords are required, etc.
2.Choose the right access control equipment, including access controllers, card readers, door sensors, electric locks, etc.
3.Design the wiring scheme of the access control system, and determine the wiring mode and location of the card reader, door magnetic, electric lock and other equipment of each door.
Second, install the equipment.
According to the design plan, the installation of the access control system equipment began. The specific steps are as follows:
1.Install the access controller: Install the access controller on the wall or column, and connect the power and communication cables.
2.Install the card reader: Install the card reader on the wall on the inside of the door, about 1 from the ground2 meters in height.
3.Install the door sensor: Install the door sensor on both sides of the door, about 20 cm above the ground.
4.Install the electric lock: Install the electric lock on the door leaf and choose the appropriate installation method according to the type of lock.
5.Commissioning Devices: Commissioning each device to make sure they are working properly.
3. Set up an access control system.
After completing the installation of the device, start setting up the access control system, the specific steps are as follows:
1.Configure system parameters: Set the control mode, card type, password rules, and other parameters of the system according to your requirements.
2.Authorized Users: Assign access permissions to users, set the access control and operation methods they can access (such as card swiping, password, etc.).
3.Test the system: Test the entire access control system to ensure that all equipment is functioning properly and without failure.
4.Maintenance and update: Regularly maintain and update the access control system to ensure the stability and security of the system.
Through the above steps, the setup of the access control system can be completed. During installation and use, you need to pay attention to the following points:
1.During installation, care should be taken to protect the equipment and lines to avoid damage or short circuits.
2.In the process of use, it is necessary to regularly check the operation status and integrity of the equipment, and find and solve problems in time.
3.During the maintenance and update process, it is necessary to follow the operating specifications and safety requirements to ensure the stability and security of the system.