Heat conduction oil furnace is a new type of environmentally friendly heat energy conversion equipment. The electric heat conduction oil boiler is fueled by coal, heavy oil, light oil, combustible gas and other combustible materials, and the heat conduction oil furnace is used as the heat carrier. The circulating oil pump is used to force the liquid phase circulation, and the heat energy is transmitted to the heating equipment, and then returned to the reheated direct flow special industrial furnace.
Although electric conductive oil boilers do not require water treatment equipment and do not cause corrosion problems, they can also produce fouling problems, but this scaling process is slower than the stroke of scale, and the types of fouling are oil coking and carbon deposits. The chemical composition of heat transfer oil is prone to chemical reactions such as high-temperature oxidation, cracking differentiation and thermal polycondensation due to heating, which makes the oil gelatinized. The coke particles generated by the polycondensation reaction greatly increase the residual carbon value of the heat transfer oil, and form a coke oil scale on the heat transfer surface. Once the fouling reaches a certain level, the heat transfer coefficient will also be greatly reduced, the energy consumption in the production process will increase, the service life of the equipment will be shortened, and if some of the auxiliary thin pipes in the furnace are blocked due to serious fouling, it will also produce very dangerous safety problems. Therefore, the timely cleaning of the heat transfer oil furnace is an important problem faced by the heat transfer oil heating system.
In fact, no matter what it is, as long as it is used, it must be cleaned. Do you know how to clean the electric heat transfer oil boiler? After all, the electric heat conduction oil boiler is to help customers adjust the temperature and keep the temperature, and only by preparing for cleaning can we better help customers.
Clean the filter regularly every two or three weeks when in use. Later, determine whether to clean according to the condition of the heat transfer oil. Once a year, the viscosity, flash point, carbon residue and acid number of the heat transfer fluid are measured, and you can have the heat transfer oil company test this test. If it is determined that the heat transfer fluid has reached the end of life standard, then change the oil and clean the boiler.
The electric heat conduction oil boiler is generally to be pickled and other methods to remove rust and other debris inside the furnace tube, and then cleaned with water, and then dried with compressed air. Cleaning process: discharge old oil, pre-washing, main cleaning, water washing, water washing, water washing, refueling, dehydration, normal operation. When the oil is discharged, the temperature is 80 100 to the outward, and when it is almost empty, the air compressor is used to blow the pressure in the high groove. Leave unused for 12 hours after cleaning, then open all blowdown valves to drain water.
The cleaning of the electric heat conduction oil boiler is a crucial part in the process of use, and the customer should pay attention to this problem and carefully learn the cleaning skills.