EDM cleaning device breaks the cleaning problem
EDM Cleaning Device: Breaking the Cleaning Problem The EDM Cleaning Device Breaks the Cleaning Problem.
EDM is the process of using electrical energy to generate heat to dissolve and decompose various dirt attached to the workpiece. During the cleaning process, the electrode discharges the water with impurities such as oil stains, dust or water vapor, which destroys the finish of the surface of the object to be cleaned. At the same time, it will also change the requirements of the coating material for the quality of the substrate, reduce its service life, and even lead to defects such as equipment damage and corrosion deformation. Therefore, it is difficult for traditional methods to effectively remove these smudges and obtain good results, but the purpose of completely solving the above problems can be achieved by improving the working method. **Barros Qingxi
It takes a lot of manpower and material resources to use electricity. At present, the cleaning process commonly used in China is completed by two methods: high-pressure water jet method and chemical immersion method. This approach requires a significant capital investment. In recent years, the number of production lines of China's industrially developed enterprises has been increasing, and there are more and more waste liquids produced every year due to environmental pollution, which seriously affects the image of enterprises. Therefore, it is urgent to develop new and efficient cleaning methods.
EDM can be used for grease and dirt on mechanical parts, as well as for peeling and degumming plastic products. Because the product has the effect of energy saving and consumption reduction, and does not contain phosphate and sodium nitrite, it greatly reduces the harm to human health; At the same time, the unit can also be operated at room temperature. When the temperature varies between 25°C and 50°C, simply put the power switch in distilled water and it can start automatically, saving electricity and labor working time.
Since the cleaning process does not require the addition of cleaning agents. The traditional method can only be rinsed with water for a few minutes, which cannot guarantee that the metal surface will not be corroded and embroidered. And too much water pressure can also affect the performance of the product.
EDM can be used instead of chemical cleaning agents such as alkaline ointments, sodium bicarbonate and organic solvents. Their main function is to form a dense protective film on the metal surface, prevent foreign substances from entering the metal inside, and play the role of slow release and peeling.
In general, there are high requirements for the cleaning of flammable and explosive dangerous goods, and special environmental disinfection areas and gas purification facilities must be set up, and sufficient amounts of sterilized drugs must be equipped to prevent microorganisms from spreading diseases. For chemical cleaning, it is understood that Barros services cover pre-cleaning pre-film before chemical plant production, pipeline degreasing and passivation and chemical plant cleaning, large-scale oil tank three-dimensional spray cleaning, chemical plant pre-demolition cleaning and replacement, oil tank robot operation and other service areas, focusing on serving the field of chemical cleaning for many years and has received wide attention and praise in the industry.