The following article about experience sharing: the introduction of stainless steel cutting fluid replacement precautions is quite good, by reading the following article, you can have a more in-depth understanding of this.
Experience Sharing Stainless steel cutting fluid replacement precautions
Stainless steel cutting fluids are important dosage forms used for cooling and lubrication in metalworking processes. Regular replacement of cutting fluid can keep it in good working condition, improve cutting efficiency and machining quality of the workpiece. The following are the precautions for stainless steel cutting fluid replacement, including mixing with water, use, and recommendations:
1. Mixing with water: Before replacing the cutting fluid, the waste liquid should be completely emptied. Then, according to the requirements of the cutting fluid formula, mix an appropriate amount of water into a clean container. Remember, cutting fluid formulations are designed for specific machining needs, so it's important to mix water in the right ratio to ensure the fluid's performance and effectiveness.
2.Use: After mixing with water, stir the water and cutting fluid thoroughly. Then, pour the mixed cutting fluid into the cutting fluid groove. Before filling with new cutting fluid, waste fluid should be completely removed from the tank to ensure that there is no contamination or mixing of different formulations of cutting fluid.
3.Recommendation: Cutting fluids can be contaminated with bacteria and impurities during use, therefore, in order to keep cutting fluids in good working condition, it is recommended to clean and disinfect them every once in a while.
In addition, the following should be paid attention to when changing the cutting fluid:
Pay attention to personal safety: When changing cutting fluid, be sure to wear personal protective equipment such as gloves and goggles to prevent cutting fluid damage to ** and eyes.
Regular inspection: Regularly check the pH value, concentration and appearance of the cutting fluid to ensure that it meets the machining requirements.
Disposal of waste: Waste cutting fluids need to be disposed of correctly and in compliance with local environmental regulations. Do not pour directly into the drain or soil.
Pay attention to storage: After use, the cutting fluid should be stored in a cool, dry and well-ventilated place, avoiding direct sunlight and high temperature environments.
Replacing stainless steel cutting fluid requires attention to water, use and recommendations. Proper operation and maintenance can extend the service life of the cutting fluid and improve the machining quality and productivity of the workpiece.