Rail drawers are one of the common storage devices in home life, which can easily store all kinds of items. However, there are times when the drawer gets stuck on the track and cannot be pulled out. This article will show you how to properly remove the rail-mounted drawer so that it can be easily pulled out of the rails.
1. Preparations.
Before you start disassembly, make sure you have the following tools ready:
1.Screwdriver.
2.Hammer.
3.Flat nose pliers.
4.Lubricants (such as motor oil or butter).
Second, the disassembly steps.
1.Observe the construction of drawers and tracks. Inspect the surface of drawers and rails to understand their structural characteristics for better disassembly.
2.Loosen the track screws. Locate the set screws on both sides of the track and use a screwdriver to loosen them. Be careful not to remove the screws completely, just loosen them.
3.Disassemble the rail slider. On the side of the track, locate the slider and use flat pliers to remove it. Sliders are usually made up of two small pieces that need to be separated and carefully removed.
4.Disassemble the tracks. Gently pull the track out of the bottom of the drawer, taking care not to push too hard to avoid damaging the drawer or track.
5.Lubricate the tracks. Apply lubricant to the surface of the track and to the slider to reduce friction and make the drawer slide more easily.
6.Reassemble. Reinstall the slider onto the track and push it back to the bottom of the drawer. Tighten the screws to ensure that the track is secured to the drawer.
3. Precautions for operation.
1.During disassembly, be careful not to damage the surface of the drawer or track so as not to affect its aesthetics and service life.
2.When it comes to lubricant use, do not use too much or too little to avoid affecting the normal sliding of the drawer.
3.When reassembling, make sure that the slider is installed correctly and the screws are tightened firmly so as not to affect the use effect.
4. Safety Tips.
1.Please use appropriate tools during operation, do not use unsuitable tools or operate directly by hand to avoid injury.
2.When using lubricants, care should be taken to avoid contact with ** or eyes to avoid causing discomfort or injury.
3.If you are not familiar with disassembly or repair, it is recommended to ask a professional to assist in the operation to ensure safety and effectiveness.
In conclusion, with the above steps and precautions, you should be able to easily pull the rail-style drawer off the track and have it repaired or replaced. This is a very important skill for the maintenance and updating of home storage equipment, and I hope it will help you.