The steps to install the toilet rubber ring are as follows:
Place the toilet upside down on clean floor with the bottom of the toilet facing up. This is done to facilitate the installation of toilet rings.
Place the toilet bowl sealing rubber ring over the sealing hole at the bottom of the toilet bowl. During placement, care needs to be taken to ensure that the toilet bowl sealing rubber ring completely covers the sealing hole without any voids. This step may require some patience and care, so please refer to the manual or seek professional help.
Turn the toilet bowl over and place it in the pre-prepared installation position. In this process, it is necessary to pay attention to the toilet drain should be aligned with the drain pipe to ensure smooth drainage.
Press down firmly on the toilet bowl so that the toilet bowl sealing ring fits well. This step requires force, either by asking a male friend to help or by using a special tool to press it together.
After the above steps are completed, the toilet rubber ring is basically installed. It should be noted that attention should be paid to details during the installation process to ensure that every link is in place to avoid errors. If you get stuck, you can seek help from a professional.
In general, the installation of toilet rubber seats requires patience and care, and each step must be carefully executed. Pay attention to details during the installation process to ensure that every link is in place to avoid errors. If you get stuck, you can seek help from a professional. Autumn and Winter Check-in Challenge