1. Check the host and auxiliary parts before use, and check whether the power cord is intact.
2. Due to the weight of the probe itself and the internal design, the continuous vibration of the probe may strain the user's hand.
3. In order to avoid the accumulation of heat on the probe, it is necessary to ensure that the top and base vents of the probe will not be blocked.
4. You can use a small amount of gel or other lubricant on the care site, not too much, to prevent the lubricant from entering the inside of the handle.
5. The life of each bullet is about 1 million times, and it is recommended to replace it if it is used for 1 million times, and it is recommended to replace it once after using it for 100,000 times. If the use of the bullet is interrupted, the barrel of the gun should be removed and the bullet should be inserted from the front end with a small iron rod. When replacing the bullet body and probe, the machine must be stopped first, and then the connecting cable between the handle and the instrument must be unplugged, and the sensitive part should not be aimed at any time.
6. The rubber pad is struck about 300,000 times, and it should be replaced immediately if the wear is serious, and if it is not replaced in time, it will break the magnet or cause the handle to not work normally. If the sealing ring is broken, it should be replaced in time, as it will leak if it is not replaced, which will affect the strength and penetration. The probe is a wearing part that will wear out naturally for a long time, and the depression exceeds 2mm and needs to be replaced, and if it is not replaced in time, it will damage the barrel.
7. Before turning on the machine, observe whether the water in the filter cup is full, the water in the filter cup must be cleaned before it is full, it is recommended to pour out the water before each use, and wipe the dirt on the inside of the filter cup with a paper towel (note: if the water is not poured out, the water will flow backwards and damage the air pump).
8. The ballistic tube is recommended to be dredged with a brush dipped in lubricating oil every two days, and when taking it off, you need to grab the metal thread and gently pull it back and pull it back.
9. Before use, you should drink more water according to your physique, and in case of special circumstances or accidents, please stop using it immediately and consult a professional.
10. During use, it is necessary to ensure that the probe head, the front end of the handle, and the back end of the handle are all tightened, and cannot be empty. Failure to tighten will cause the machine to weaken and damage the barrel of the gun. When operating, the impact head must be in close contact ** to activate the control buttons of the handle.