To make a 1kv five-core heat shrinkable cable head, you can follow the steps below:
Clean the part where the cable head needs to be installed. Including the surface treatment of wires and joints to maintain their good insulation properties and the effect of the protective layer;For possible moisture or stains, it should be removed in advance. Also check that the nose is intact (make sure there are no burrs or bumps). If possible, the cold air can be dried before wiring to drive away the exhaust, which helps to improve safety and avoid the risk of short circuits. Note: This is a very important and easily overlooked link!
For the inserted part, flatten it with sandpaper and trim it in place (try to replace it with a new one if necessary) to ensure a tight fit to prevent poor contact or even circuit breaking problems caused by loosening;It is also very important that the applicator used to extrude it is strong and reliable!Be sure to follow the correct operating procedures in all processes to avoid unnecessary troubles or even accidents! Move the prepared shield to the appropriate position and secure it. The finishing work is to clean up the site and carry out the necessary sorting and sorting to complete the whole process. 。Due to the different models produced by different manufacturers and the uneven quality, it is recommended to choose the brand products of regular manufacturers when purchasing to ensure quality and after-sales service. The above content is for reference only, and the specific details are intended to obtain accurate information and advice.
Precautions: Be sure to ensure the quality of the material and do not ignore the potential safety hazards because of small losses. Pay attention to the safety of yourself and others during the construction process, and abide by relevant local laws and regulationsHope it helps!