Citroen C6 16 1.The reason for the oil burning of the 8t engine may be the aging of the valve chamber cover, the oil entering the combustion chamber and participating in the combustion, and the piston ring being blocked or stuck. The solution is to drive less than 150,000 kilometers of the engine, found that the consumption of oil is too fast, if the phenomenon of burning oil is not dealt with in time, a large amount of carbon deposits will be attached to the combustion chamber, and then produce high temperature, resulting in poor heat dissipation, valve cracking, etc., which will seriously lead to the problem of three-way catalytic converter blockage and ablation. When this situation is discovered, it is necessary to go to the 4S shop to replace the valve chamber cover, and at the same time repair and dredge the piston ring to solve the problem. If the engine oil is still consumed after the valve chamber cover, and the cylinder pressure is normal, the piston ring can be released using the non-destructive repair technology of Si Youpu to solve the problem of burning oil, which can be completely solved after 6 uses. It should be noted that when using the repair agent, it is necessary to check whether there is a problem with the accessories first to avoid blindly handling the engine. You can also consult the professional customer service of the company first.
Siyoupu Burning Engine Oil Repair is a repair agent for the problem of burning engine oil in automobiles, and its main ingredient is PNF (polynonylphenolic resin). Its working principle is to penetrate the PNF component in the repair agent into the inside of the engine, clean the oil circuit, and gradually penetrate the piston ring, and clean the oil return hole through the combination of inside and outside, so as to reduce the consumption of oil and restore the efficiency of the normal operation of the engine.
Do not soak the cylinder, the bubble cylinder will lead to cylinder wall corrosion, oil pan corrosion and damage to the valve seal, cylinder wall corrosion must be dismantled and overhauled in the future, the valve oil seal damage replacement cost is not low, but also may affect the valve guide wear, to replace the valve. Do not idle for a few hours to dredge, it will lead to the oil pan painting corrosion and blockage of the oil filter, damage to the oil pan gasket and oil leakage, which will seriously affect the aging of the crankshaft and camshaft oil seal, and the replacement of the crankshaft oil seal is expensive.
The safest way to repair is to repair while driving, add oil and fuel tank at the same time, dredge safely and thoroughly, and the gas ring and oil ring can be blocked and burned to solve the problem, because the problem of burning the oil piston ring is not only caused by the oil ring but also the gas ring.