How to clean the dirty and blocked air conditioning pipes.
Dirty air-conditioning pipes are a common problem, if not cleaned in time, it will affect the normal operation of the air conditioner, and if not cleaned in time, it will affect the normal operation of the air conditioner. If not cleaned in time, it will cause fouling, corrosion and even damage to the condenser and evaporator, reducing the cooling effect and shortening the service life of the air conditioner. We need to clean the air conditioning lines regularly! Let's introduce you to the relevant content about how to clean the air conditioning pipes and how to clean the air conditioning pipes! 1. Unplug the power supply before cleaning to avoid danger; Two: Open the air conditioner panel and find the main filter (such as the radiator) in the air conditioning system. Use a brush to gently scrub stains and debris from the inner wall of the pipe, then rinse with water. to check if there is anything sticky left on the filter. (Note that the air conditioner does not bring dust into the indoor unit during operation).
3. After disassembly, be sure to carefully check the status of each component of the air conditioner to see if there is any abnormal situation; Four: After the cleaning is completed, the host should be reinstalled back to the original place; 5. Turn on the power switch of the external machine, let the machine stop running for about 5 minutes, observe whether there is any leakage, and then turn off the external switch.
How to clean the dirty and blocked air conditioning pipes.
For chemical cleaning, it is understood that Barros services cover pre-cleaning pre-film before chemical plant production, pipeline degreasing and passivation and chemical plant cleaning, large-scale oil tank three-dimensional spray cleaning, chemical plant pre-demolition cleaning and replacement, oil tank robot operation and other service areas, focusing on serving the field of chemical cleaning for many years and has received wide attention and praise in the industry.
The way to clean the air conditioning ducts is to first remove the heat sink of the condenser and evaporator, and then clean it with a brush aimed at the edge of the housing. Next, rinse it with clean water and plug in the power cord. Finally, wipe dry with a rag.
If the pipe blockage is severe, only some tools can be used to clean it. Generally speaking, the main dirt in the air conditioning line is dust, bacteria and other dirt attached to the filter screen, and peculiar smells. Here are a few common tips.
Open the air conditioner panel, find the exhaust outlet (note: the grounding wire cannot touch any part of the indoor unit), and fasten the soft connection and the disconnected end together, loosen the fixing screws, and remove the filter (note: be sure to tighten it). , whether there is leakage, and at the same time to see if there is a short circuit phenomenon and so on. (1) Start the machine to run for about 5 minutes, observe whether there is water flowing out of the drain pipe, if there is, it means that the system is seriously hypoxic or desulfurized, and it needs to be shut down for cleaning. In addition, be careful not to let the sewage flow into the sink or other places in the kitchen, so as not to affect the next cleaning work. Leave it on for 5-10 minutes, and then take it out of the air conditioner after the liquid has fully reacted. until all the dirt is completely dissolved, then rinse thoroughly with water! Check the temperature of the main engine and the change of pressure at each point (adjust to the maximum value to ensure normal air circulation during the cleaning process).