The inspection cycle of the filter is usually determined according to the specific use case. In general, it is recommended to inspect and clean the Y filter every 3-6 months. If the water quality used is poor or the filter is used more frequently, the inspection cycle can be shortened appropriately.
During the inspection, the following aspects need to be noted:
Remove the filter:According to the instructions provided by the manufacturer, remove the Y filter.
Check the filter:Inspect the filter for clogging, wear, or damage, and replace it if necessary.
Cleaning the filter:Clean the filter thoroughly with clean water or detergent to ensure that the surface of the filter is free of dirt.
Install the filter:Reinstall the cleaned filter into the water pipe in the correct way, making sure the connection is tight.
Check the effect:After reusing the filter, pay attention to the quality of the effluent, and if there is any abnormal situation, it should be dealt with in time or contact the manufacturer for maintenance.
In conclusion, regular inspection and cleaning of the filter is an important step to ensure its proper operation and effective filtration, which can improve water quality and extend the life of the filter. The specific inspection cycle also needs to consider the actual situation and the recommendations of the Detersen manufacturer.
Fujian Detersen valve***