Before you start reading this article, you may not know much about the size standard of the floor tile surface layer compartment joint, but after reading, you must have a deeper understanding of it.
The size standard of the sub-warehouse joint of the floor tile surface layer refers to the regulation of the size of the gap left between the floor tiles and the floor tiles when laying the floor tiles. Reasonable slot size can effectively reduce the cracking and deformation of floor tiles, and improve the paving effect and service life.
The size standard of the floor tile surface layer is usually determined according to the size of the paved floor tiles and the requirements of the installation environment, generally speaking, the size of the sub-warehouse joint is -3mm. The following factors need to be considered when making a specific choice:
1. Floor tile size: the larger the floor tile, the larger the size of the sub-warehouse joint, and the larger the gap can be left for the general large-size floor tile.
2.Construction environment: If it is a dry environment or the foundation is relatively flat, the size of the sub-silo joint can be appropriately reduced; If it is a humid environment or the foundation settlement is uneven, the size of the sub-silo joint should be appropriately increased.
3.Paving effect: The moderate size of the sub-warehouse joint can ensure that the paving effect of the floor tiles is more beautiful, but too large or too small the gap will reduce the paving effect.
The selection of the size standard of the floor tile surface layer sub-warehouse joint needs to be adjusted according to the specific needs and circumstances, and the appropriate gap size can be determined according to the relevant national norms and standards and the suggestions of professionals.